AEG 403 manual Connecting the water supply, Proceed as follows

Page 29

Proceed as follows:

Remove the machine’s worktop by unscrewing the two rear retaining screws, pull from the front and slide out the slots, lifting the worktop.

Insert the machine after adjusting the level with the adjustable feet.

When inserting the machine, ensure that the water inlet and drain hoses are not kinked or squashed.

Connecting the water supply

Your dishwasher has been built in accordance with the valid regulations governing water-consuming appliances and is equipped with safety devices which prevent used water from flowing back into the drinking water mains. Your dishwasher can be connected to either a cold or hot water supply of max. 60°C.

Never connect your dishwasher to open hot water appliances and continuous flow heaters!

The supply hose is fitted with a screwed hose connection (to DIN 259) and can be connected to an outlet valve (water tap) with male thread (3/4").

Suitable washers are supplied with the machine. Do not use any washers other than these!

The nut of the screwed hose connection can be tightened by and. If you re- quire a supply hose which is longer than the one supplied, use only the VDE- approved complete hose kit (obtainable from our service centre) continuously and to adequate length.

Never lengthen existing hoses.

Important note! The supply hose must not be kinked, squashed, or twisted. Please ensure careful running.

To avoid reductions in water supply to the kitchen, we recommend you to install a separate tap. Failing this, fit a branch piece to the existing water tap.

Additional installation expenditure (on the building side) can be reduced by use of conventional sink mixers with connection and shutoff valve.

29

Page 28 Page 30
Image 29
Page 28 Page 30
Contents Favorit Contents Using your dishwasher for its intended purpose Safety instructionsBefore using your dishwasher for the first time Child safetyYour dishwasher in day-to-day use Disposing of packaging and old machine Disable the door lock so that the door no longer closesDisposing of the packaging Disposing of your old machineUnsuitable crockery Important hintsFollowing items have certain machine washing limitations Suitable crockeryDescription of the appliance Water hardness adjustment Central filter Levelling spacersInside of the appliance Upper basket stopUse Type of soil Load Selector Pushbutton Position Washing programmesCold prewash Setting the water hardness range Before using your dishwasher for the first timeFilling with special salt To adjust the water softenerFilling up the rinse-aid Salt refill indicatorRinse-aid Tighten firmly the cover Setting the rinse aid quantity to be addedRinse aid replenishment indicator After filling the dispenser with detergent, close the lid Adding dishwashing detergentPhosphate free detergents with enzymes Lower basket Loading your machineCutlery basket Upper basket At the end of the programme Operating instructionsSet and start the programme Care instructions Internal and external cleaningCleaning the central filter Dishwasher must not be used without filters Cleaning the large filterServicing Dishwasher will not drain Dishes are not clean poor washDoor is difficult to close Visible lime deposits or white film on the dishesCustomer service Capacity Technical dataAllowable water pressure Electrical connectionPositioning InstallingLevelling Adapting the work-topProceed as follows Connecting the water supplyMaximum allowable water pressure Water outlet connectionMinimum water pressure Electrical connection Extension hosesAEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG
Top Page Image Contents