Operating instructions
Set and start the programme
Push the plug into the socket.
Open the water supply.
Close the dishwasher door.
Turn the programme selector dial clockwise, until the letter of the required programme is opposite the indicator mark on the control panel.
Press the On/Off pushbutton; the pilot light comes on and the programme starts.
In general it is not advisable to open the door while the machine is working; if the door is opened however, a safety device ensures that the machine stops.
If you wish to interrupt the wash programme at any time press the On/Off button.
Depressing the On/Off button again the programme will start from the point where it was interrupted.
At the end of the programme
At the end of the washing programme the machine stops automatically.
The pilot light remains on until the On/Off button is depressed.
Switch off the dishwasher by pressing the On/Off button and open the door.
When the wash programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off.
Do not open the door during the hot phase: this may cause hot water escape.
Care must be taken if the door is opened immediately after a programme has finished, as steam may escape.
Wait a few minutes before removing the dishes; in this way they will be cooler and drying will be improved.
Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one.
21