Antunes, AJ VCT-50, VCT-20, VCT-25 owner manual Installation, Unpacking, Assembling the Unit

VERTICAL CONTACT TOASTER

		INSTALLATION
Unpacking				Conveyor
1.	Remove unit and all packing materials from ship-			Cover Assy.
	ping carton.
2.	Open the large box. It should contain:		Heat Shield
	•	Bun chute (Figure 2)
	•	Plastic bag containing the release sheet
		(Figure 4)
3.	Remove all packing materials and protective cov-		Yellow Support
	erings from the unit and parts.
			Rod
NOTE:		If any parts are missing or damaged, con-
tact Antunes Technical Service IMMEDIATELY at
1-877-7854-392.
Assembling the Unit
1.	Remove heat shield along with front and rear
	conveyor covers (Figure 1).
2.	Install the damper assy. (Figure 1).		Conveyor
			Cover Assy.
NOTE: Make sure the damper assy. rests only on			Figure 1. Installing Damper Assy.
the bottom front and rear yellow support rods.
3.	Install the bun chute (Figure 2).		Hook Bun Chute over rear	Heat Shield
			bottom conveyor cover
4.	Remove the release sheet from the plastic bag		yellow support rod	Conveyor
	and lay it on a clean, flat surface. Fold the sheet
				Cover Assy.
	exactly in half (Figure 3).

5. Crease the sheet at the fold using only your fin- ger (Figure 3).

NOTE: Do not use metal tools to crease the sheet.

6.Install the release sheet by draping it over both sides of the platen surface. The crease should be centered directly on top of the platen (Figure 4).

CAUTION Failure to use release sheets may result in dam- age to the unit and loss of warranty coverage.

7.Re-install the front and rear conveyor covers (Figure 4).

IMPORTANT: Make sure the covers rest only on both the top and bottom yellow support rods.

8.Install the heat shield assy. The heat shield clips fit over the top of the platen and retains the release sheet (Figure 4).

Yellow Support Rod

Conveyor	Bun Chute
Cover Assy.

Figure 2. Installing Bun Chute

P/N 1010729 Rev. C 05/04 7