AEG 25742 GM installation instructions Connection to the gas supply

Page 14

Connection to the gas supply

Ensure that the gas type at the installation site is the same as that stated on the appliance rating plate.

On the end of the shaft, which includes the GJ 1/2” threaded elbow, adjustment is fixed so that the washer is fitted between the components as shown in the diagram. Screw the parts together without using excessive force.

 

A

 

B

 

C

A) End of gas shaft with nut

B)

Washer

C)

Elbow

Connection

Connection to the gas supply should be with either rigid or semi-rigid pipe, i.e. steel or copper.

The connection should be suitable for connecting to RC 1/2 (1/2 BSP male thread). When the final connection has been made, it is essential that a thorough leak test is carried out on the hob and installation using leak detection fluid.

Ensure that the main connection pipe does not exert any stain on the hob.

It is important to install the elbow correctly, with the shoulder on the end of the thread, fitted to the hob connecting pipe.

Failure to ensure the correct assembly will cause leakage of gas.

14

Image 14
Contents Hob 25742 GM Page During use For Your SafetyInstallation Service and Spare Parts Child safetyCleaning and maintenance Environmental InformationContents Hob control knobs Description of the hobInstructions for use Lighting the burners Correct use of the hobHob Cleaning and maintenanceGeneral cleaning Ignition plugSymptom Solution Something Not Working0870 5 929 Guarantee Conditions European GuaranteeTechnical Data By-pass diametersLocation of appliance Instructions for the installation technicianProvision for ventilation Connection to the gas supply ConnectionElectrical connection YESAdapting to the different types of gas Replacing the power supply leadSetting the minimum level Changing the nozzlesBuilding into fitted kitchen units Insertion and fixingOn base cabinet with oven Installation optionsOn base cabinet with door Page Tip. Montagnani Mo Cod