Failure Code and Troubleshooting
Problem
The programme will not start
Water remains inside the dishwasher at the end of the
programme
The dishwasher stops in the middle of a programme
Wash performance is of a low standard
White stains on the dishes
The dishes are not completely dry at the end
of the programme
There are rust stains on the dishes
Possible cause
Check the plug, fuse and circuit breakers of the mains supply
The water tap is turned off
The dishwasher door is not fully closed
The water inlet filter or the machine filters are blocked
The water drain hose is blocked or kinked.
The filters are blocked
Power failure
Water inlet failure
Programme is on standby
Poor loading of dishes hinders wash performance.
Insufficient detergent added
Inappropriate wash programme selected
Spray arm blocked
Filters clogged or incorrectly fitted
Water drain pump blocked
Insufficient detergent added
Rinse aid setting is too low
Insufficient dishwasher salt added
Water softener setting is too low
Salt compartment cap not completely closed
A programme without a drying stage was selected
Rinse aid setting is too low
Dishes unloaded too soon (allow time for drying)
Different sets of cutlery should be kept separate Too much salt (Water softener setting is too high)
Salt compartment cap not completely closed
Poor appliance earth (check mains electrical supply)
The door is not opening or closing properly | Door tension not correctly adjusted for the décor door |