Softener adjustment
The efficiency of your dishwasher depends on the softness of the tap water. To ensure best efficiency, the dishwasher is equipped with a system that reduces the hardness in the mains water supply. The efficiency will increase when the system is correctly set. To find out the water hardness level of your water supply you can use the test strip supplied or alternatively contact your local water board.
No Lime
Very low lime content
Low lime content
Medium lime content
Lime content
High Lime content
1.Open the testing strip.
2.Run water through the tap for one minute.
3.Hold the testing strip in water for one second.
4.Shake the testing strip after taking it out of the water
5.Wait for one minute
6.Check the number of marks on the strip to see the level of water hardness.
If the hardness of the water you use is above 63dE0 or if you are using well water; you are recommended to use filter and water refinement devices.
Please note: The level of water hardness is preset to level 3.
1.Press and hold down the programme selection button
2.Press the power button to switch on the dishwasher
3.Keep the programme selection button pressed until the five programme indicator lights and the end of programme indicator light flash.
4.To adjust the level, press the programme selection button until the required level is selected. The programme lights will illuminate as in the table of water hardness settings.
5.To store the selected water hardness level, press the power button.