Antunes, AJ MS-250/255, MS-355 owner manual Generator

Page 17

MIRACLE STEAMER

A.J. Antunes & Co.

Problem

Possible Cause

Corrective Action

 

 

 

Steam from generator is

Restrictor tube or generator tubes are

Clean restrictor tube and/or generator

reduced compared to former

clogged.

tubes.

operation.

 

 

Flooding condition.

Allow 20 minutes for excess water to evapo-

 

 

 

rate and generator to recover to 375°F.

 

 

 

 

Insufficient preheat.

Allow excess water on the generator casting

 

 

to evaporate and preheat 20 minutes before

 

 

operating. DO NOT operate steamer during

 

 

preheat cycle.

 

 

 

 

Filters require cleaning.

See page 14.

 

 

 

 

Control board setpoint temperature

Surface temperature of the casting should

 

too low.

be between 375°- 425° F (191°- 218°C)

 

 

when the red light on the control board

 

 

turns off. If the temp is too low, contact

 

 

maintenance or AJA Authorized Service

 

 

Center.

 

Heavy deposit buildup on the genera-

See maintenance procedure under Cleaning

 

tor.

Generator.

 

 

 

Unit becomes flooded or

Incorrect water pressure.

*(Regulated units only.) Set water pressure

always steaming. Power

 

to 20 psi (138 kPa).

ON, solenoid makes a chat-

 

 

 

 

May need to cleaned or replaced. Contact

tering noise.

Solenoid valve inoperable or particles

or

in the valve.

maintenance or AJA Authorized Service

 

Center.

 

 

Unit floods overnight. Power

 

 

Control board is not programmed

Verify programming as described in the

OFF.

properly.

Programming section.

 

 

 

 

 

Control board is inoperable.

Contact maintenance or AJA Authorized

 

 

Service Center.

 

 

 

Water leaking in the

Pin hole leak in the hoses.

Replace the hoses.

electrical housing.

 

 

Inlet tube or restrictor tube is loose.

Tighten the loose fittings.

 

 

 

 

 

Generator tube is loose or damaged.

Tighten loose fittings or contact mainte-

 

 

nance or AJA Authorized Service Center.

 

 

 

 

 

 

16

 

P/N 1010699 Rev. B

 

 

 

 

 

 

Image 17
Contents Miracle Steamer Owner Information Table of ContentsModel Designation MS-150XX Important Safety InformationService/Technical Assistance Miracle Steamer Electrical Cord & Plug Configurations SpecificationsElectrical Ratings Voltage Watts Amps HertzMiracle Steamer DimensionsUnpacking InstallationEquipment Setup Filling Water Tank-MS-150/155 Model MS-250/255 OperationProgramming Operating Instructions1500 Sho Steaming Tips Hi-Limit Reset ButtonCleaning Steam Generator MaintenanceDaily MonthlyMiracle Steamer Components Direct water hook-up Units MS-250/255 Water Filters-Models MS-150/155Problem Possible Cause Corrective Action TroubleshootingGenerator Miracle Steamer MS-150/155/250/255 Replacement PartsItem Part No Description Qty Inset a Model MS Inset B Model MS Inset C Model MS Inset B Model MS Inset a Model MS Item Part No Description MS-355Inset a Model MS 79 C Inset B Model MS 69 65 Part Description Qty Replacement PartsUnless Otherwise Specified Wiring DiagramsAntunes & CO

MS-250/255, MS-355 specifications

Antunes is a leading manufacturer known for its high-quality commercial kitchen equipment, with a particular emphasis on foodservice solutions that enhance efficiency and performance. Among their notable products are the AJ MS-355 and MS-250/255 models, which exemplify the brand's commitment to innovation and reliability in the foodservice industry.

The Antunes AJ MS-355 is a versatile foodservice equipment piece designed for cooking and toasting items such as sandwiches, bagels, and more. One of its standout features is the advanced infrared heating technology, which ensures even cooking and consistent results. This model is equipped with dual heating elements, providing the flexibility to heat from both the top and bottom, allowing for optimal baking results that can be adjusted based on food type and desired browning.

In contrast, the MS-250/255 models are tailored for businesses that require a high volume of cooking capabilities. These models are particularly known for their compact design, allowing them to fit seamlessly into various kitchen layouts without compromising on performance. The MS-250 offers a dual-belt system that enables simultaneous cooking of multiple items, while the MS-255 takes this a step further with an additional feature that allows for the cooking of larger batches in a shorter amount of time.

Both models emphasize energy efficiency, which is crucial for modern kitchens looking to reduce overhead costs. They incorporate smart technology that not only optimizes energy consumption but also minimizes heat loss, providing operational savings and promoting sustainability. Furthermore, the intuitive digital controls on these appliances allow for precise temperature management and timing, which is essential for maintaining food quality.

Another key characteristic of the Antunes AJ MS-355 and MS-250/255 is their durability and ease of cleaning. Constructed from high-grade stainless steel, these units are designed to withstand the rigors of a busy kitchen, resisting corrosion and wear. The removable components make cleaning straightforward, ensuring that hygiene standards are met without significant downtime.

In summary, the Antunes AJ MS-355 and MS-250/255 models are exemplary pieces of equipment that embody efficiency, performance, and ease of use, making them indispensable tools for any commercial kitchen looking to enhance its cooking capabilities while maintaining quality and operational efficiency.