Ventilation
The room containing the cooker should have an air supply in accordance with B.S. 5440: Part 2: Current Editions.
The following requirements for ventilation must be met.
The cooker should not be installed in a bed sitting room with a volume of less than 20m3, if it is installed in a room of volume less 5m3 an air vent of effective area of 110cm2 is required; if it is installed in a room of volume between 5m3 and 10m3, an air vent of effective area 50cm2 is required, while if the volume exceeds 11m3 no air vent is required. However, if the room has a door, which opens directly to the outside, no air vent is required even when the volume is between 5m3 and 11m3.
If there are other fuel burning appliances in the same room, B.S. 5440: Part. 2: Current Editions should be consulted to determine the requisite air vent requirements.
Location
The cooker may be located in a kitchen, a kitchen/diner or bed sitting room but not in a bathroom, shower room or garage.
For information regarding the fitting of flexible supply pipes, the highest temperature at the rear of this cooker which may come into contact with the supply pipe is 70°C above ambient.
When the appliance has been installed there must be enough space for the hotplate lid (when present) to open fully.
L.P.G. cookers or ovens MUST NOT be installed below ground level, i.e. in a basement, or aboard any boat, yacht or other vessel.
Levelling |
|
|
|
| ||
Fix the support with two legs with the washer |
| |||||
and nuts, delivered with the cooker, see the |
| |||||
figure. |
|
|
|
| ||
• Unscrew the legs as far as possible (approx. | 4 | |||||
| 16mm from fully screwed in). |
|
| |||
• |
|
| 5 | |||
Place the plinth (pos.3) so that the springs | ||||||
3 | ||||||
| (pos.2) reach the threaded area of the legs | |||||
|
| |||||
| and the clamp of the plinth (pos.4) is in front |
| ||||
| of the holes (pos.5) on the under side of the |
| ||||
• | structure. |
|
|
| 2 | |
Push the plinth | towards the | appliance | with | |||
1 | ||||||
| both hands until | the springs | fasten on | the | ||
|
| |||||
legs and the clamps go into the corresponding holes.
•Adjust the legs as necessary.
20