GAS CONNECTIONS
Your cooker is delivered adjusted for the kind of gas stated on the rating plate
If the appliance is supplied with natural gas and the pressure for natural gas is 20mbar. The following methods of connection to the gas supply must be used:
Right Hand Connection (from front)
Ensure that the rubber hose is not in contact with any part of the hatched area shown in the diagram and that the loop of the hose when connected is not in contact with the floor when the appliance is in position.
Left Hand Connection (from front)
Ensure that the rubber hose is not in contact with any part of the hatched area shown in the diagram and the hose is retained in the clamp provided, it will be necessary to fit the maximum length hose when using this method.
BACK OF THE COOKER
power cord
connection |
|
of flexible |
|
hose | clamps |
|
BACK OF THE COOKER
power cord
connection
of flexible hose
clamps
Fixing and use of the 2 clips provided with the cooker
The enclosed gas hose fixing clips must be fixed to the back of the cooker, dependant on the position of the supply bayonet connector (see fig.).
When selecting the most suitable position for the clips, please ensure that the gas hose cannot come into contact with any part of the “Hot” zone when pushing the cooker into its final position.
Finally, secure the hose into the clips.
Rigid Connection
Where it is not possible to make the connection using a rubber hose, a rigid pipe work connection must be used.
Recommendations when using an appliance flexible connector are as follows:
-For NATURAL the gas installation pipes to the termination point shall comply with:
Specification for installation of
clip
Clip Position
Options
Connection shall be by means of an appliance flexible connector for use with a
Flexible hoses, end fittings and sockets for gas burning appliances – BS 669;
21