Sigma KS-342 manual Accessories, etc, About the case

KS-342

NOTE

If the unit is not to be used for an extended period of time, remove the batteries from the unit. Do not leave dead batteries in the unit.

The batteries are contained in a standard battery holder, which slides out for easy replacement. Additional battery holders can be purchased and “pre-loaded” with spare batteries for easy and speedy replacement.

Accessories, etc.

The Kamesan KS-342 is supplied with everything you need to start work.

However, you can purchase the following, in order to increase the capabilities and the functionality of the unit:

Power adaptors: you can use the Kamesan PS-M12 mini power supply.

Spare battery holders, allowing you to slip in a new power source at a moment’s notice. Use the BP-3/8 battery holder for dry cell batteries, and the BH-1 for the NiCd NP-1 battery.

To expand the capabilities of the unit further, it is possible to fit

aKS-6001 4-channel sub-mixer, and/or a KS-6002 4-channel EQ/compressor unit, both of which integrate neatly into the KS- 342 system without the use of cables.

Consult your Kamesan supplier for details.

About the case

The Kamesan KS-342 case is designed to hold and protect the unit against any wear and tear under the standard conditions of use for which the mixer is designed. In addition, the mixer itself has been designed to be rugged and to stand up to the demands that will be made of it in its expected life.

Even so, you should not drop the mixer, or subject it to violent shocks or vibration. Always keep the mixer in its case to avoid any possible damage.

You can loosen the straps on the case in order to expand the case size and allow the side strap holders on the mixer to be freed from the retaining panels in the case.

If you remove the mixer from the case, and then replace it, al- ways make sure the case clips (four in all) fit over the lip at the top of the mixer front panel.

7