Maytag X9112VUV Oven Light, Electrical Connection, Broiler Bottom, Remove broilerbottom from oven

MAINTENANt;E

OVEN OR BROILER DOOR

Do not place excessive weight on an open oven door or stand on an open oven door as, in some oases, it could damage thedoor, cause the appliance to tip overand possiblycause injury,

When openingoven door,allowsteam and hotair to escapebeforereachingin ovento check,add or removefood.

Do not attempt to open or close door until door is completely seated on hinge arms. Neverturnonoven unless dooris properlyin place. When baking, be sure

door is completely c(osed. Baking results will be affected if door is not

securely closed.

OVEN BO'I'I'OM

Protectoven bottomagainst excessive spillovers especially acid or sugary spiltovers as they may discolor the porcelain.Use the correctsize cooking utensilto avoidboitovers.Never place

cookware or aluminum foil directlyon the oven bottom,

To remove: When cool, remove the ovenracks,Pushtheovenbottomtothe

rear of the oven and lift up at front until thefronted_eofthecvenbottomclears the oven front frame• Remove oven bottom from oven.

OVEN LIGHT

The oven light switchis located on the controlpanel. Push in rockerswitchto turn oven_ighton and off,

Before replacing oven light bulb,

DISCONNECT POWER TO OVEN. Be sure bulband oven parts are cool. Do

nottoucha hotbulbwitha dampclothas the bulbmay break.

To replace oven light: Use a dry pot

holder, to prevent possible harm to hands; very carefully remove bulb. Replace with a 40 watt APPLIANCE bulb. Reconnect power to the oven.

ELECTRICAL CONNECTION

To remove door: Open door to the "stop" position (opened about 4 to 6 inches) and graspdoorwithboth hands at each side. Do not use doorhandle to

lift door. Lift up evenly until door clears the hinge arms.

i_

		Appliances which require electrical
		power are equipped with a
		three-prong grounding plug which
.....	-	must be plugged directly intoa properly
		grounded three-hole 120 volt electrical
		outlet.

To replace: Fit the rear edge of oven
of the channel on the rear oven wall.
Push toward rear of oven and lower		(_ _
oven bottom into place.		)_2.._)
BROILER BOTTOM
To remove: When cool,removebroiler
pan and oven rack. Liftup front edge of		_
bottom into the pin located at the center
broilerbottom.Then lift rear end up and	4	disconnectpower to app/iance
remove broilerbottom from oven,	before servicing.
To replace 12-inch broiler bottom:

Place two slots along rear flange over

two screws in rear wall. Then, lower frontedge intoplace,

To replace 6-inchbroiler bottom: Push bottom to rear and lower into

place.

The three-prong groundingplug offers

protectionagainst shock hazards. Do not cut or remove the third

grounding prong from the power cord plug.

To replace door: Grasp door at each side, align slots in the door with the hingearmsandslidedoordownontothe hinge arms until completelyseated on hinges,

If an ungrounded, two-hole or other type electrical outletis encountered, it

is the personal responsibility of the appliance owner to have the outlet

replaced with a properly grounded three-hole electrical outlet.