Maytag W10649077A Option A, Waste disposer no air gap, Option B, No waste disposer no air gap

IMPORTANT: The drain hose connection of the disposer or a waste tee must be made before the drain trap and at least 20" (50.8 cm) above the floor where the dishwasher will be installed.

Helpful Tip: To reduce vibration of the hose, keep the hose away from the floor.

Option A, Waste disposer – no air gap

Helpful Tip: Remove disposer knockout plug.

1.Using a hammer and screwdriver,

knock plug into disposer.

2. Use needle-nose pliers to remove plug.

3. Attach drain hose to disposer inlet with large drain hose clamp (provided). Use pliers to squeeze clamp open and move into position.

Option B, No waste disposer – no air gap

1.Fit rubber end of drain hose to waste

tee and cut if needed.

NOTE: Do not cut ribbed section.

2. Attach rubber end of drain hose to waste tee with a large drain hose clamp (provided). Use pliers to squeeze clamp open and move into position. If the drain hose was cut, use a 1¹⁄₂" to 2" (3.8 to 5 cm) screw- type clamp (not provided).

Option C, Waste disposer – with air gap

Helpful Tip: Remove disposer knock-out plug.

1.Using a hammer and screwdriver,

knock plug into disposer.

2. Use needle-nose pliers to remove plug.

3.Connect rubber end of drain hose to air gap and cut if needed.

NOTE: Do not cut ribbed section.

4.Attach drain hose to air gap with

large drain hose clamp (provided). Use pliers to squeeze clamp open and move into position. If the drain hose was cut, use a 1¹⁄₂" to 2" (3.8 to 5 cm) screw-type clamp (not provided).

5.Use a rubber hose (not provided)

with screw-type clamps (not provided) to connect from air gap to disposer inlet.

10