Extron electronic GSS 100 manual Symbol definitions, X4 = Device name

Command and Response Table for IP- and Port-specific SIS Commands

Symbol definitions

X4) = Device name (Up to 240 alphanumeric characters)

NOTE: The following characters are invalid or not recommended in the name: {space} + ~ , @ = ` [ ] { } < > ‘ “ ” ; : \ and ?.

X4! = Default name	GSS-100- + last 3 pairs of MAC address
X4@ = Time and date (for set)	In the format: MM/DD/YY•HH:MM:SS where:	MM = month: 01 (Jan) through 12 (Dec)
		DD = day: 01 through 31
		YY = year: (20)00 through (20)99
		HH = hour: 00 through 23
		MM = minutes: 00 through 59
		SS = seconds: 00 through 59

X4# = Time and date (for read)

In the format: Day,•DD•Mmm•YYYY•HH:MM:SS where: Day = weekday: Mon through Sun DD = date: 01 through 31 Mmm = month: Jan through Dec YYYY = year: 2000 through 2099 HH = hour: 00 through 24

MM = minutes: 00 through 59

SS = seconds: 00 through 59

X4$ = GMT offset			–12.0 through +14.0. Hours and minutes removed from GMT
X4%	=	Daylight Saving Time	0	= Daylight Saving Time off/ignore	2	= Daylight Saving Time on (Europe)
			1	= Daylight Saving Time on (North America)	3	= Daylight Saving Time on (Brazil)
X4^ =		IP address	nnn.nnn.nnn.nnn
X4& = Hardware (MAC) address			nn-nn-nn-nn-nn-nn
X4*	= Number of open connections		0	– 255
X4( = Password			12 alphanumeric characters

NOTE: The following characters are invalid or not recommended in passwords: {space} + ~ , @ = ` [ ] { } < > ‘ “ ” ; : \ and ?.

X5)	= DHCP		0 =off, 1 = on
X5! =		Port number	00 – 99 (00 = all ports)
X5@ = Baud rate			2400, 3600, 4800, 7200, 9600, 14400, 19200, 28800, 38400, 57600, 115200
X5# =		Parity	odd, even, none, mark, space

NOTE: For the X5# parameter, use the first character only. The parameter is case insensitive.

X5$ =	Data bits	7 or 8 (8 = default)
X5% =	Stop bits	1 or 2 (1 = default)
X5^ =	Port timeout	The number of seconds (in 10-second steps) before timeout on the IP connections:
		minimum = 1 (10 seconds), maximum = 6500 (65,000 seconds or just over 18 hours),
		default = 30 (300 seconds or 5 minutes). If no data is received during the timeout period, the Ethernet
		connection is closed. Applicable to Ethernet connection only; when connected via the RS-232 port, only
		the global timeout commands apply.
X5& =	Verbose mode	0	= clear or none (default for Telnet connection)
		1	= verbose mode (default for RS-232 or RS-422 connection)
		2	= tagged responses for queries
		3	= verbose mode and tagged for queries
NOTE: If tagged responses is enabled, all read commands return the constant string and the value as the set command does
	(for example, the read matrix name command ECN} returns Ipn•X4)]).

GSS 100 Graphic Still Store • Programming Guide 26