Extron electronic GSS 100 manual Command and Response Table for IP-Specific SIS Commands

Command and Response Table for IP-Specific SIS Commands

Command	ASCII Command	Response	Additional description
	(host to unit)	(unit to host)

IP and port setup commands

Set device name Read device name

Reset device name to factory default

Set time and date Read time and date Set GMT offset

EX4)CN}	Ipn•X4)]
ECN}	X4)]
E•CN}	Ipn•X4!]
EX4@CT}	IptX4@]
ECT}	X4#]
EX4$CZ}	IpzX4$]

“GSS-100” plus the last three pairs of the MAC address.

In the command, the divider between hours and minutes can be either a colon (:) or a period. In the response, the divider is a colon.

Example:

Set Daylight Saving Time Read Daylight Saving Time Set IP address

Read IP address

Read hardware address Read # of open connections Set subnet mask

Read subnet mask

Set gateway IP address Read gateway IP address Set administrator password Read administrator password

Reset (clear) administrator password

Set user password Read user password Reset (clear) user password Set DHCP on or off

Read DHCP on/off status Set serial port parameters

Example:

Read serial port parameters Configure current port timeout View current port timeout Set global IP timeout

View global IP timeout Set verbose mode Read verbose mode

E8.0CZ}	Ipz+08:00]
EX4%CX}	X4%]
ECX}	X4%]
EX4^CI}	IpiX4^]
ECI}	X4^]
ECH}	X4&]
ECC}	X4*]
EX4^CS}	IpsX4^]
ECS}	X4^]
EX4^CG}	IpgX4^]
ECG}	X4^]
EX4(CA}	Ipa•X4(]
ECA}	X4(]
E•CA}	Ipa•]
EX4(CU}	Ipu•X4(]
ECU}	X4(]
E•CU}	Ipu•]
EX5)DH}	IdhX5)]	X5): 0 = off, 1 = on
EDH}	X5)]
EX5!*X5@,X5#,X5$,X5%CP} CpnX5!•CcpX5@,X5#,X5$,X5%]
E01*9600,N,8,1CP}	Cpn01•Ccp9600,N,8,1] Set the the RS-232 port to 9600
		baud, no parity, 8 data bits, and 1
		stop bit.
E01CP}	X5@,X5#,X5$,X5%]
E0*X5^TC}	Pti0*X5^]
E0TC}	X5^]
E1*X5^TC}	Pti0*X5^]
E1TC}	X5^]
EX5&CV}	VrbX5&]
ECV}	X5&]

GSS 100 Graphic Still Store • Programming Guide 27