Maytag UMV1152CA manual A3.MOUNT THE MICROWAVE OVEN, Installation Instructions

Installation Instructions

Installation Instructions

A3. MOUNT THE MICROWAVE OVEN

FOR EASIER INSTALLATION AND PERSONAL SAFETY, WE RECOMMEND THAT TWO PEOPLE

INSTALL THIS MICROWAVE OVEN.

IMPORTANT: Do not grip or use handle during installation.

NOTE: If your cabinet is metal, use the nylon grommet around the power cord hole to prevent cutting of the cord.

NOTE: We recommend using filler blocks if the cabinet front hangs below the cabinet bottom shelf.

IMPORTANT: If filler blocks are not used, case damage may occur from over tightening screws.

NOTE: When mounting the microwave oven, thread power cord through hole in bottom of top cabinet. Keep it tight throughout Steps 1–3. Do not pinch cord or lift oven by pulling cord.

1.Lift microwave, tilt it

forward, and hook slots at back bottom edge

onto four lower tabs of mounting plate.

2.Rotate front of oven

up against cabinet bottom

3.Insert a self-aligning screw through top center cabinet hole. Temporarily secure the oven by turning the screw at least two full turns after the threads have engaged. (It will be completely

tightened later.) Be sure to keep power cord tight. Be careful not to pinch the cord,

especially when mounting flush to bottom of cabinet.

Cabinet Front

Cabinet Bottom Shelf

Filler Block

Equivalent to

Depth of

Cabinet Recess

Self-Aligning Screw

Microwave Oven Top

4.Attach the microwave oven to the top cabinet.

5.Insert 2 self-aligning screws through outer top cabinet holes. Turn two full turns on each screw.

6.Tighten center screw completely.

7.Tighten the outer two screws to the top of the microwave oven. (While tightening screws, hold the microwave oven in place against the wall and the top cabinet.)

8.Install grease filters. See the Owner’s Manual packed with the microwave.

13

A – 14 16027303 © 2006 Maytag Services