Maytag UMV1152CA manual C2.ATTACH THE MOUNTING PLATE, TO THE WALL cont, For Outside Back Exhaust

Installation Instructions

Installation Instructions

C2. ATTACH THE MOUNTING PLATE		C4. ADAPTING MICROWAVE BLOWER
TO THE WALL (cont.)		FOR OUTSIDE BACK EXHAUST
To use toggle bolts:		1.Remove and save screw that holds blower Plate
	Spacing for Toggles More	to microwave.
		Blower motor
	Than Wall Thickness
		screw.
			2.Lift up the Blower Plate.
	Toggle Wings
Mounting	Toggle		Blower Motor
Plate	Bolt
			Back of
			Microwave
	Wall
	Bolt End
			Blower Motor
3.Place the mounting plate against the wall and			Screw
		3.Carefully pull out the blower unit. The wires will
insert the toggle wings into the holes in the wall to
		extend far enough to allow you to adjust the
mount the plate.
		blower unit.
NOTE: Before tightening toggle bolts and wood		BEFORE: Fan Blade		End B
screw, make sure to coincide bottom line of the		Openings Facing Forward
Mounting plate with Horizontal line of “Rear wall
Template” and then the Mounting plate is properly
centered under the cabinet.
CAUTION: Be careful to avoid pinching fingers		End A
between the back of the mounting plate and the wall.
4.Tighten all bolts. Pull the plate away from the wall
to help tighten the bolts.		CAUTION: Do not touch blade of blower to prevent
		cracking and breaking. Hold outer case when the
C3. USE TOP CABINET TEMPLATE		blower is removed and re-installed.
		4.Remove “Parts “A” with Nipper or Scissors
FOR PREPARATION OF TOP
CABINET
You need to drill holes for the top support screws and
a hole large enough for the power cord to fit through.			Knockouts

Parts”A”

5.Rotate blower unit counterclockwise 180°.

Before Rotation After Rotation

• Read the instructions on the TOP CABINET
TEMPLATE.
• Tape it underneath the top cabinet.	Back of
• Drill the holes, following the instructions on the	Microwave
	Back of
TOP CABINET TEMPLATE.
	Microwave
CAUTION: Wear safety goggles when drilling holes in
the cabinet bottom.

19

A – 20 16027303 © 2006 Maytag Services