PROGRAMMING - H5-ELEMENT
Adjusting temperature:
The switch must be in the “SET” position in order to access the program modes.
1.Press and hold “TEMP” button until display flashes.
2.While display is flashing, press and release the
(+) to increase or
If unit is “E” model, temp will stop at 210°F (99°C). If unit is “X” model, temp display will jump from 210°F (99°C) to 212°F (100°C).
Refer to chart on page 3 and adjust temperature requirements according to altitude.
Program lockout switch:
The switch must be in the “SET” position in order to access the program modes.
1.Disconnect the dispenser from the power source.
2.Remove the
3.Use a small screwdriver to move switch to set position.
4.Install top cover, connect dispenser to power source.
SET
LOCK
Manual Energy Saver Mode:
The energy save mode will allow the tank temperature to drop down to 140°F (60°C).
1.Simultaneously press and release the (+) and
2.The display will alternately flash between 140 and the current temperature to indicate it is in the energy save mode.
3.Repeat procedure to exit energy save mode.
Step forward
Step backward
Programming the dispenser:
1.Press and hold upper hidden button (bottom center of “BUNN” logo) until “P1” is displayed.
Continued
11 | 46819 061212 |
|