OPERATING CONTROLS - PORTION CONTROL ONLY
(a) VOLUME SELECTOR BUTTONS |
| |
Press and release the button corre- | c. | |
sponding to the Small, Medium, or | ||
| ||
Large volume, to select the desired |
| |
amount of water to be dispensed. |
| |
Pressing a different button after a |
| |
cycle has been initiated does not |
| |
change the volume in progress. |
| |
(b) AUTO STOP/MANUAL DISPENSE |
| |
BUTTON |
| |
Press and release button to stop a |
| |
dispense cycle. Press and hold button |
|
to dispense manually.
(c) HIDDEN PROGRAMMING BUTTON a.
(d)LED INDICATORS
(e)DISPENSE NOZZLE
e.
ADJUSTING DISPENSE VOLUMES
NOTE: The dispenser should be at operating temperature before setting dispense volumes.
d.
b.
1.Press and hold the hidden programming button (c) located under the ® next to the BUNN logo on the front of the dispenser until the 3 LED's begin flashing from the left to the right. Release the button.
2.Place an empty graduated container under the dispense nozzle (e).
3.Press and release the batch size to be set (a). The LED's will stop flashing, and the LED over the button just pressed will come on steady. Water will begin to dispense into the container.
4.When the desired amount of water is dispensed, press and release the same button (a). The water will stop dispensing and the batch size is now set.
5.The LED's will begin flashing from left to right again. Repeat steps 2 thru 4 to set up the other batch sizes.
6.To exit the programming set up at any time, press and release the hidden button once (c). The dispenser is now ready for use.
8 | 46819 043012 |
|