Contents
Henny Penny Pressure Fryer Model PFE-590 Model PFE-592
OPERATOR’S MANUAL
Page
FM05-032-G Revised
LIMITED WARRANTY FOR HENNY PENNY EQUIPMENT
HENNY PENNY 8 HEAD ELECTRIC PRESSURE FRYER
SPECIFICATIONS
Section
TABLE OF CONTENTS
Page
Page
1-1. PRESSURE FRYER
SECTION 1. INTRODUCTION
1-2. PROPER CARE 1-3. ASSISTANCE
P-H-T
CAUTION used with the safety alert symbol indicates a
CAUTION used without the safety alert symbol indicates
a potentially hazardous situation which, if not avoided
may result in property damage
Equipotential Ground Symbol
1-5. SAFETY Continued
Waste Electrical and Electronic Equipment WEEE Symbol
Shock Hazard Symbols OR Hot Surface Symbols OR
SECTION 2. INSTALLATION
2-2. UNPACKING
7. Remove the counterweights from the pallet, which are
INSTRUCTIONS
strapped to the pallet, under the fryer
Model PFE- 590/592
Optional Ramp Unloading
1103
Model PFE- 590/592
2-3. SELECTING THE
2-5. VENTILATION OF FRYER
Units being used outside the United States may not be shipped
2-7. INTERNATIONAL ELECTRICAL REQUIREMENTS Continued
BOIL-OVER PREVENTION IN HENNY PENNY COOKERS
Model PFE- 590/592
SECTION 3. OPERATION 3-1. OPERATING COMPONENTS
A microswitch that provides protection for the frypot in the event an
3-1. OPERATING COMPONENTS Continued
To open lid 1. Gently raise handle until it stops
INDICATORS
3-4. SWITCHES AND
Time/Temperature Display
Heat Indicator
The display reads “HI” if the shortening temperature is 40 F above
TEMPERATURE BUTTON
3-4. SWITCHES AND INDICATORS Continued
PRODUCT BUTTONS
DIGITAL DISPLAY
3-5. FILLING OR ADDING SHORTENING
3-6. BASIC OPERATION
10. Unlock and raise the lid cautiously
1. To protect the shortening when the fryer is not in immediate
3-8. FILTERING INSTRUCTIONS continued
the frypot rim. Damage to the frypot rim could result and
Do not bang the pot scraper, or other cleaning utensil, on
the lid may not seal properly during a cook cycle
IF THERE ARE AIR BUBBLES COMING UP IN THE
or severe burns could result
3-11. FILTER PUMP MOTOR PROTECTOR-MANUAL RESET
3-10. CLEANING THE FRYPOT Continued
3-12. REGULAR MAINTENANCE SCHEDULE
Procedure
3-13. PREVENTIVE MAINTENANCE
4. Clean the gasket and gasket seat with hot water
1. Use a wrench to remove pressure gauge
3-14. PROGRAMMING
After the load compensation, press and release the
After the filter value is set, press and release the FUNCTION
Factory Presets F/C, Gas/Electric, Speaker Volume
Reset Usage
3-15. SPECIAL PROGRAM MODE
Continued
Tech I/O Mode
3-15. SPECIAL PROGRAM MODE
Continued
Heat Control
3-15. SPECIAL PROGRAM
MODE Continued
Problem
SECTION 4. TROUBLESHOOTING 4-1. TROUBLE SHOOTING GUIDE
Cause
Correction
DISPLAY
4-2. ERROR CODES
CAUSE
PANEL BOARD CORRECTION
Model PFE- 590/592
Model PFE- 590/592
G L O S S A R Y
HENNYPENNYPRESSUREFRYERS
gas fryers only
shortening level also referred to as level indictor lines
Model PFE- 590/592
gas fryers only
Model PFE- 590/592
gas fryers only
gas fryers only
Model PFE- 590/592
head fryers. the lid assembly includes spindles
place see lid latch
gas fryers only
gas fryers only
Model PFE- 590/592
see ignition modules
Toll free in USA FM05-032-G*1-800-417-8417 1-800-417-8434 Fax
Henny Penny Corporation P.O.Box Eaton,OH
Henny Penny Corp., Eaton, Ohio 45320, Revised