Henny Penny PFE-590, PFE-592 manual Special Program Mode, Reset Usage, Continued

		Model PFE- 590/592
3-15. SPECIAL PROGRAM MODE		Reset Usage
(Continued)	1.	Press and hold the FUNCTION button for two seconds until
		“REG PROGRAM” shows in the display. As soon as “REG
		PROGRAM” shows in the display, press and release the
		FUNCTION button 2 times until “RESET USE” shows in
		display.
	2.	When “CODE” shows in the display, press 1-3-5. “DAILY
		will show in the display, and press any of the product buttons
		to reset them to 0.
		Factory Presets (F/C, Gas/Electric, Speaker Volume,
		Speaker Frequency, Codes, Initialize System)
	1.	Press and hold the FUNCTION button for two seconds until
		“REG PROGRAM” shows in the display. As soon as
		“REG PROGRAM” shows in the display, press and release
		the FUNCTION button 3 times until “FAC PRESET” shows
		in the display.
	2.	When “CODE” shows on the display, enter 2-9-5-7. “DEG”
		and “MODE” flashes in the display. Press any of the product
		buttons to toggle from ºF to ºC, and vice versa.
	3.	Press and release the FUNCTION button and “TYPE”
		and “FRYR” flashes in the display. Press any of the product
		buttons to toggle from “GAS” to “ELEC”, or vice versa.
	4.	Press and release the FUNCTION button twice, and
		“SPKR” and “VOL” flashes in the display. The volume can
		be changed from 01 to 10, 10 being the loudest.
	5.	Press and release the FUNCTION button 3 times, and
		“SPKR” and “FREQ” flashes in the display. The frequency
		can be set from 100 to 2000.
	6.	Press and release the FUNCTION button 10 times, and
		“INITIALIZE SYSTEM” scrolls across the display. Press
		and hold any of the product buttons and the display counts
		down from 5. Once the display counts down, release the
		product button, and the control sets factory preset param-
		eters into the controls.
		Before attempting to change the other modes in the Factory
		Preset Mode, please call the Henny Penny Technical Service
		Department at 1-800-417-8405, or 1-937-456-8405.
403		3-22