Manuals / Henny Penny / Kitchen Appliance / Fryer

Henny Penny PFE-590, PFE-592 SAFETY Continued, Equipotential Ground Symbol, Model PFE- 590/592

Models: PFE-590 PFE-592

1 52

Download 52 pages 9.73 Kb

Page 9

1-5. SAFETY (Continued)

Model PFE- 590/592

1-5. SAFETY (Continued)

Equipotential Ground Symbol

Waste Electrical and Electronic Equipment (WEEE) Symbol

Shock Hazard Symbols

OR

Hot Surface Symbols

OR

908

1-3

Image 9

Henny Penny PFE-590 SAFETY Continued, Equipotential Ground Symbol, Waste Electrical and Electronic Equipment WEEE Symbol

Contents

Henny Penny Pressure Fryer Model PFE-590 Model PFE-592 OPERATOR’S MANUALPage FM05-032-G Revised LIMITED WARRANTY FOR HENNY PENNY EQUIPMENTHENNY PENNY 8 HEAD ELECTRIC PRESSURE FRYER SPECIFICATIONSTABLE OF CONTENTS SectionPage Page 1-1. PRESSURE FRYER SECTION 1. INTRODUCTION1-2. PROPER CARE 1-3. ASSISTANCE P-H-TCAUTION used with the safety alert symbol indicates a CAUTION used without the safety alert symbol indicatesa potentially hazardous situation which, if not avoided may result in property damageEquipotential Ground Symbol 1-5. SAFETY ContinuedWaste Electrical and Electronic Equipment WEEE Symbol Shock Hazard Symbols OR Hot Surface Symbols ORSECTION 2. INSTALLATION 2-2. UNPACKING 7. Remove the counterweights from the pallet, which areINSTRUCTIONS strapped to the pallet, under the fryerOptional Ramp Unloading Model PFE- 590/5921103 Model PFE- 590/592 2-3. SELECTING THE 2-5. VENTILATION OF FRYER Units being used outside the United States may not be shipped 2-7. INTERNATIONAL ELECTRICAL REQUIREMENTS Continued BOIL-OVER PREVENTION IN HENNY PENNY COOKERS Model PFE- 590/592 SECTION 3. OPERATION 3-1. OPERATING COMPONENTS A microswitch that provides protection for the frypot in the event an 3-1. OPERATING COMPONENTS Continued To open lid 1. Gently raise handle until it stops INDICATORS 3-4. SWITCHES ANDHeat Indicator EXIT COOL ButtonThe display reads “HI” if the shortening temperature is 40 F above TEMPERATURE BUTTON 3-4. SWITCHES AND INDICATORS ContinuedPRODUCT BUTTONS DIGITAL DISPLAY3-5. FILLING OR ADDING SHORTENING 3-6. BASIC OPERATION 10. Unlock and raise the lid cautiously 1. To protect the shortening when the fryer is not in immediate 3-8. FILTERING INSTRUCTIONS continued the frypot rim. Damage to the frypot rim could result and Do not bang the pot scraper, or other cleaning utensil, onthe lid may not seal properly during a cook cycle IF THERE ARE AIR BUBBLES COMING UP IN THEor severe burns could result 3-11. FILTER PUMP MOTOR PROTECTOR-MANUAL RESET 3-10. CLEANING THE FRYPOT Continued3-12. REGULAR MAINTENANCE SCHEDULE Procedure3-13. PREVENTIVE MAINTENANCE 4. Clean the gasket and gasket seat with hot water 1. Use a wrench to remove pressure gauge 3-14. PROGRAMMING After the load compensation, press and release the After the filter value is set, press and release the FUNCTION Factory Presets F/C, Gas/Electric, Speaker Volume Reset Usage3-15. SPECIAL PROGRAM MODE Continued3-15. SPECIAL PROGRAM MODE Tech I/O ModeContinued 3-15. SPECIAL PROGRAM Heat ControlMODE Continued Problem SECTION 4. TROUBLESHOOTING 4-1. TROUBLE SHOOTING GUIDECause CorrectionDISPLAY 4-2. ERROR CODESCAUSE PANEL BOARD CORRECTIONModel PFE- 590/592 Model PFE- 590/592 G L O S S A R YHENNYPENNYPRESSUREFRYERS gas fryers onlyshortening level also referred to as level indictor lines Model PFE- 590/592gas fryers only Model PFE- 590/592gas fryers only gas fryers onlyModel PFE- 590/592 head fryers. the lid assembly includes spindlesplace see lid latch gas fryers onlyModel PFE- 590/592 gas fryers onlysee ignition modules Henny Penny Corporation P.O.Box Eaton,OH Toll free in USA FM05-032-G*1-800-417-8417 1-800-417-8434 FaxHenny Penny Corp., Eaton, Ohio 45320, Revised