Henny Penny PFE-590, PFE-592 manual To open lid 1. Gently raise handle until it stops

Model PFE- 590/592

3-2. LID OPERATION Continued)

DO NOT LIFT HANDLE OR FORCE LID LATCH

OPEN BEFORE PRESSURE GAUGE READS “0”

PSI. ESCAPING STEAM AND SHORTENING WILL

RESULT IN SEVERE BURNS.

TO AVOID SERIOUS PERSONAL INJURY, DO NOT

OPERATE WITHOUT LID COVER IN PLACE AND

ALL COMPONENTS INSTALLED.

TO AVOID SERIOUS PERSONAL INJURY, DO NOT

TAMPER WITH ANY COMPONENT OF LID

LOCKING MECHANISM.

To open lid:

1.Gently raise handle until it stops.

2.Push handle back until it stops.

3.Lower handle.

Lower the handle before attempting to raise the lid, or damage to the lid could result.

4.Push handle back.

5.Unlatch the front lid latch.

3-3. MELT CYCLE OPERATION If the shortening is below 185o F (85o C), with the POWER/PUMP switch in the POWER position, the fryer will enter the Melt Cycle. The shortening heats slowly to prevent scorching of the shortening. The heat cycles on and off to slowly melt the shortening. At 185o F (85o C), the heat stays on until 250o F (121o C), the Cool Mode, is reached. To exit the Cool Mode, press the EXIT COOL button.

See Filling andAdding Shortening Section.

703 3-4