Henny Penny PFE-592, PFE-590 manual After the filter value is set, press and release the FUNCTION

		Model PFE- 590/592
3-14. PROGRAMMING	13.	After the filter value is set, press and release the FUNCTION
(Continued)		button. “EOC” and “EXIT” flashes on the left side
		of the display, and “COOL” shows on the right side of the
		display. The end-of-cycle (EOC), exit point can be set to
		COOL, SETP, or FLTR, by pressing any of the product
		buttons (EOC). At the end of a Cook Cycle, the controls
		can be set to return to: COOL, the setpoint temperature, or
		to signal the operator to filter the shortening.
	14.	After the end-of-cycle setpoint is set, press and release the
		FUNCTION button. “HEAD” and “COUNT” flashes on
		the left side of the display and a number shows on the
		right side of the display. The number on the right, is the
		number of head of chicken to be cooked when that product
		button is pressed. The number can be changed by
		pressing the appropriate product button.
		Another product can be programmed while in the Program
		Mode by following these procedures:
		Press and hold the SCAN button at any time while in the
		Program Mode, and the display scrolls “SELECT
		PRODUCT”. Then press any of the product buttons,
		(1-0), and now that product can be programmed.
	15.	To program second interval, press and release the SCAN
		button while in the Time Mode, of the first mode. “INT2”
		and “TIME” flashes on the left side of the display. Then
		follow the steps above, starting with step 4.
3-15. SPECIAL PROGRAM MODE		Review Usage
	1.	Press and hold the FUNCTION button for two seconds until
		“REG PROGRAM” shows in the display. As soon as
		“REG PROGRAM” shows in the display, press and release
		the FUNCTION button 1 time until “REVIEW USE” shows
		in the display.
	2.	“DAILY” shows in the display. Press any of the product
		buttons to view the usage of that product. Press and hold the
		FUNCTION button to exit Special Program Mode.
3-21		403