Manuals / Henny Penny / Kitchen Appliance / Fryer

Henny Penny PFE-592 manual SWITCHES AND INDICATORS Continued, Temperature Button, Product Buttons

Models: PFE-590 PFE-592

1 52

Download 52 pages 9.73 Kb

Page 26

3-4. SWITCHES AND INDICATORS (Continued)

Model PFE- 590/592

3-4. SWITCHES AND INDICATORS (Continued)

TEMPERATURE BUTTON

DIGITAL DISPLAY

PRODUCT BUTTONS

Figure 3-2

3-7

403

Image 26

Henny Penny PFE-592, PFE-590 manual SWITCHES AND INDICATORS Continued, Temperature Button, Product Buttons, Digital Display

Contents

OPERATOR’S MANUAL Henny Penny Pressure Fryer Model PFE-590 Model PFE-592Page LIMITED WARRANTY FOR HENNY PENNY EQUIPMENT FM05-032-G RevisedSPECIFICATIONS HENNY PENNY 8 HEAD ELECTRIC PRESSURE FRYERPage TABLE OF CONTENTSSection Page 1-2. PROPER CARE 1-3. ASSISTANCE SECTION 1. INTRODUCTION1-1. PRESSURE FRYER P-H-Ta potentially hazardous situation which, if not avoided CAUTION used without the safety alert symbol indicatesCAUTION used with the safety alert symbol indicates a may result in property damageWaste Electrical and Electronic Equipment WEEE Symbol 1-5. SAFETY ContinuedEquipotential Ground Symbol Shock Hazard Symbols OR Hot Surface Symbols ORSECTION 2. INSTALLATION INSTRUCTIONS 7. Remove the counterweights from the pallet, which are2-2. UNPACKING strapped to the pallet, under the fryer1103 Optional Ramp UnloadingModel PFE- 590/592 Model PFE- 590/592 2-3. SELECTING THE 2-5. VENTILATION OF FRYER Units being used outside the United States may not be shipped 2-7. INTERNATIONAL ELECTRICAL REQUIREMENTS Continued BOIL-OVER PREVENTION IN HENNY PENNY COOKERS Model PFE- 590/592 SECTION 3. OPERATION 3-1. OPERATING COMPONENTS A microswitch that provides protection for the frypot in the event an 3-1. OPERATING COMPONENTS Continued To open lid 1. Gently raise handle until it stops Heat Indicator 3-4. SWITCHES ANDINDICATORS EXIT COOL ButtonThe display reads “HI” if the shortening temperature is 40 F above PRODUCT BUTTONS 3-4. SWITCHES AND INDICATORS ContinuedTEMPERATURE BUTTON DIGITAL DISPLAY3-5. FILLING OR ADDING SHORTENING 3-6. BASIC OPERATION 10. Unlock and raise the lid cautiously 1. To protect the shortening when the fryer is not in immediate 3-8. FILTERING INSTRUCTIONS continued the lid may not seal properly during a cook cycle Do not bang the pot scraper, or other cleaning utensil, onthe frypot rim. Damage to the frypot rim could result and IF THERE ARE AIR BUBBLES COMING UP IN THEor severe burns could result 3-12. REGULAR MAINTENANCE SCHEDULE 3-10. CLEANING THE FRYPOT Continued3-11. FILTER PUMP MOTOR PROTECTOR-MANUAL RESET Procedure3-13. PREVENTIVE MAINTENANCE 4. Clean the gasket and gasket seat with hot water 1. Use a wrench to remove pressure gauge 3-14. PROGRAMMING After the load compensation, press and release the After the filter value is set, press and release the FUNCTION 3-15. SPECIAL PROGRAM MODE Reset UsageFactory Presets F/C, Gas/Electric, Speaker Volume ContinuedContinued 3-15. SPECIAL PROGRAM MODETech I/O Mode MODE Continued 3-15. SPECIAL PROGRAMHeat Control Cause SECTION 4. TROUBLESHOOTING 4-1. TROUBLE SHOOTING GUIDEProblem CorrectionCAUSE 4-2. ERROR CODESDISPLAY PANEL BOARD CORRECTIONModel PFE- 590/592 HENNYPENNYPRESSUREFRYERS G L O S S A R YModel PFE- 590/592 gas fryers onlyModel PFE- 590/592 shortening level also referred to as level indictor linesgas fryers only Model PFE- 590/592gas fryers only gas fryers onlyplace see lid latch head fryers. the lid assembly includes spindlesModel PFE- 590/592 gas fryers onlysee ignition modules Model PFE- 590/592gas fryers only Henny Penny Corp., Eaton, Ohio 45320, Revised Henny Penny Corporation P.O.Box Eaton,OHToll free in USA FM05-032-G*1-800-417-8417 1-800-417-8434 Fax