ELECTRICAL REQUIREMENTS
WARNING - The dispenser must be disconnected from the power source until specified in Initial
Refer to Data Plate on the Brewer, and local/national electrical codes to determine circuit requirements.
WHITE | NEUTRAL WHITE | POWER CORD | L2 RED | NEUTRAL BLUE | POWER CORD | |
NEUTRAL |
| N |
|
| N |
|
|
|
|
|
|
| |
L1 BLACK |
| L1 |
| L1 BLACK | L1 BROWN L1 |
|
| L1 BLACK |
|
|
| ||
|
| GREEN | GREEN/YELLOW | ||
|
|
|
|
| |
|
|
|
|
| |
| G |
|
| G |
|
120 volt ac models |
|
|
| ||
230 volt ac models | |||||
Note: This electrical service con- | Note: This electrical service con- | ||||
sists of 2 current carrying conduc- | sists of 2 current carrying conduc- | ||||
tors (L1 and Neutral) and a separate | tors (L1 and Neutral) and a separate | ||||
conductor for earth ground. | conductor for earth ground. | ||||
Electrical Hook-Up
CAUTION – Improper electrical installation will damage electronic com- ponents.
1.An electrician must provide electrical service as specified.
2.Using a voltmeter, check the voltage and color coding of each conductor at the electrical source.
3.Turn off master switch (if equipped).
4.Remove the upper and lower rear panels.
5.Install the proper electrical wiring to the terminal block.
6.Connect the dispenser to the power source and verify the voltage at the terminal block before proceeding. Reinstall both rear panels.
7.If plumbing is to be
CE REQUIREMENTS
•This appliance must be installed in locations where it can be overseen by trained personnel.
•For proper operation, this appliance must be installed where the tem- perature is between 5°C to 35°C.
•Appliance shall not be tilted more than 10° for safe operation.
•An electrician must provide electrical service as specified in conformance with all local and national codes.
•This appliance must not be cleaned by water jet.
•This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given instructions concerning use of this appliance by a person responsible for its safety.
•Children should be supervised to ensure they do not play with the ap- pliance.
• If the power cord is ever damaged, it must be replaced by the manufac- turer or authorized service personnel with a special cord available from the manufacturer or its authorized service personnel in order to avoid a hazard.
• Machine must not be immersed for cleaning.
L2 RED | L2 RED | POWER CORD |
|
| L2 |
L1 BLACK |
| L1 |
| L1 BLACK |
GREEN
G
208 & 240 volt ac models
Note: This electrical service consists of 2 current carrying conductors (L1 and L2) and a separate conductor for earth ground.
L2 RED | L2 RED | POWER CORD |
|
| L2 |
WHITE | NEUTRAL WHITE | |
NEUTRAL |
| N |
|
| |
L1 BLACK | L1 BLACK | L1 |
GREEN
G
120/208 & 120/240V ac
single phase models
Note: This electrical service consists of 3 current carrying conductors (Neutral, L1 and L2) and a separate conductor for earth ground.
DUAL VOLT TOGGLE SWITCH
5 | 46819 043012 |
|