Cuisinart WCH-1500 manual Cleaning and care, Troubleshooting, Symptom Possible Cause Solution

Page 6

Regular use of cleaner, filtered water in your automatic coffeemaker means less frequent decalcification treatments.

Use filtered water in your iron to reduce mineral build-up.

Treat your pets to cleaner, filtered water.

Cleaner, filtered water makes tea and instant soup or coffee taste better.

Keeping the upper tank full helps increase the filtering process as well as the flow rate of water from spigots.

Proper setup of the filter (as instructed on page 4) will maximize the reduction of contaminants and optimize taste of water.

You may notice some condensation and water droplets on the lid and tanks of your unit. This is normal due to the heating and cooling system.

Cleaning and care

CAUTION: To prevent personal injury or electric shock, always unplug your

Cuisinart® ® Countertop Filtration System from outlet before cleaning. Do not immerse base in water or other liquid.

1.Turn the unit off and unplug it from outlet.

2.Remove the filter and place it in a bowl.

3.Lift upper water tank and let it drain into lower tank, and set it aside. Then lift lower tank off base and empty. Careful, a full tank can be very heavy!

4.Clean the water tanks and the cover with warm soapy water. NOTE: Remove filter timer before washing lid. Filter timer is not immersible.

5.The base is not immersible. Simply wipe it clean with a damp cloth.

6.Dry thoroughly when clean.

Troubleshooting

Symptom

Possible Cause

Solution

 

 

 

On/Off Power but-

Unit might not be plugged

Check the wall outlet for power. Make sure the

ton does not light

into outlet.

outlet is not controlled by a wall switch.

up.

 

 

It takes longer than

 

Place filter in an empty bowl, then fill with

45 minutes for

Some air is still in the filter.

water, making sure it is fully submerged.

the water to pass

Resoak it for 10–15 minutes, or until no

 

through the filter.

 

more bubbles are observed.

 

 

 

 

 

Review “Filling the Internal Tanks” on page 5

Unit does not dis-

Internal water tanks are

to be sure it was done correctly. Make sure the

lower water tank is full. Continue to press and

pense water when

not completely filled with

hold push buttons until water flow is steady. If

buttons are pushed.

water.

unit still won’t dispense water or flow does not

 

 

 

 

become steady, contact Customer Service.

 

 

 

Water continues

 

 

flowing from spigot

Push button is stuck.

Remove water tanks from the base. Continue

after push button is

pressing button until it no longer sticks.

 

released.

 

 

 

 

 

 

1. Power is not on.

1. Make sure unit is plugged into outlet.

HOT water LED

2. Make sure air has been purged from

2. There is no water in

internal tanks, as stated on page 5.

does not light up.

tanks.

3. If there is water in the tanks, it will take

 

 

 

about 10 minutes for the water to heat.

 

 

 



Image 6
Contents Cuisinart Countertop Filtration System Outlet as shown in figure A. If a grounding-type outlet is Special Cord SET InstructionsFor your protection, this unit Obtained so that a 2-slot wall outlet can be usedContents Parts and FeaturesIntroduction Preparing the Water Filter Setup are completeInstalling the Prepared Water Filter Filling the Upper and Lower TanksReplacing Water Filter Initiating Energy Saver ModeSetting the Filter Timer Filling the Internal TanksCleaning and care TroubleshootingSymptom Possible Cause Solution Subsequent fill-ups Temperature water wasInstalled on the bottom of the base Cold water LED Large amount of room Light turns off evenTechnical specifications Storing the unitPerformance data sheet Performance Data Sheet for Models WCH-1000 and WCH-1500Purchases Made in Iowa Warranty Limited Three-Year WarrantyIB-8896A
Related manuals
Manual 13 pages 11.19 Kb