Briggs & Stratton CE8069, 271172, 270962, 276535 manual edge of the plug with a non-hardeningsealant

edge of the plug with a non-hardening sealant.

Figure 29

2. Install new foam seal (B, Figure 30) on

4choke shaft (E), then slide shaft into carburetor body (C). Rotate shaft clockwise (A), and insert choke valve into slot until centered, with dimples (D) positioned as shown. Actuate the choke shaft to check for proper movement.

Figure 30

3.Install new foam seal (C, Figure 31) on throttle shaft (B), then slide shaft into carburetor body. Rotate shaft until flat is facing out. Position throttle valve on flat with numbers facing out (A), then install screws (D). Actuate the throttle shaft to check for proper movement.

Figure 31

4.Install idle speed screw with spring, if equipped.

5.Using Bushing Driver #19057

(A, Figure 32), install new needle seat with grooved edge down (B) until firmly seated.

Figure 32

6.Install new inlet needle (B, Figure 33) on float (A), then position float in carburetor body. Secure with new hinge pin (C) and center the pin between the float bosses.

Figure 33

74