Briggs & Stratton 276535, 271172 Install new o-ringon fuel transfer tube E, Install Carburetor

NOTE: The holes in the throttle plate are offset. If the throttle plate is installed incorrectly, if will not close.

9.If equipped, install idle mixture screw with spring and the idle speed screw with spring. Turn each screw until the head of the screw touches the spring.

10.Insert new inlet needle (B) into the slot on the float (A, Figure 67).

11.Place the needle and float assembly into the fuel transfer tube. Secure with new hinge pin (C) and center the pin between the float bosses.

Figure 69

NOTE: The locating tang on the fuel transfer tube MUST be placed in the recess of the carburetor base as shown.

14.Insert the spring (A, Figure 70) to the bottom of the float assembly. Place the fuel bowl on the carburetor base, and fasten with screws. Torque screws per values listed in Section 12 - Engine Specifications.

4

Figure 67

12.Install new o-ring on fuel transfer tube (E).

13.Place new float bowl gasket (A, Figure 68) on the carburetor body, then press the fuel transfer tube (B, Figure 69) onto the carburetor base (C).

Figure 68

Figure 70

15.Install solenoid with new gasket. Torque solenoid to values listed in Section 12 - Engine Specifications.

Install Carburetor

1.Place new gasket between carburetor and manifold with long edge of gasket opposite the fuel inlet.

2.Hook governor link spring (B, Figure 71) in non-grommet throttle lever hole.

3.Hook governor link (A) in grommet throttle lever hole. Link fits over top of lever.

85