Extron electronic XPA 200170V, XTRA SERIES, XPA 2001100V Installation, cont’d, Rack mounting

Page 9

Installation, cont’d

1. Elevated operating ambient temperature — If installed in a closed or multi-unit rack assembly, the operating ambient temperature of the rack environment may be greater than room ambient temperature. Therefore, install the equipment in an environment compatible with the maximum ambient temperature (Tma = +122 °F, +50 °C) specified by Extron.

2. Reduced air flow — Install the equipment in a rack so that the amount of air flow required for safe operation of the equipment is not compromised.

3. Mechanical loading — Mount the equipment in the rack so that a hazardous condition is not achieved due to uneven mechanical loading.

4. Circuit overloading — Connect the equipment to the supply circuit and consider the effect that circuit overloading might have on overcurrent protection and supply wiring. Appropriate consideration of equipment nameplate ratings should be used when addressing this concern.

5. Reliable earthing (grounding) — Maintain reliable grounding of rack-mounted equipment. Pay particular attention to supply connections other than direct connections to the branch circuit (e.g. use of power strips).

Rack mounting

The XPA 1002 or XPA 2001 can be mounted in a rack shelf using the optional RSU 129 1U Universal rack shelf (Extron part #60-190-01) or the 1U Basic rack shelf (Extron part #60-604-01), as follows.

1.

If feet were installed on the bottom of the amplifier,

 

remove them.

2.

Place the amplifier on one half of the rack shelf. Align the

 

front of the amplifier with the front of the shelf, and align

 

the threaded holes on the bottom of the amplifier with the

 

holes in the rack shelf.

3.

Attach the amplifier to the rack shelf with the two

 

provided 4-40 x 3/16” machine screws. Insert the screws

 

from the underside of the shelf, and securely fasten them

 

into diagonally-opposite corners.

See the following illustration.

1U Universal Rack Shelf

1/2 Rack Width Front False

Faceplate

Front false faceplate uses 2 screws.

 

(2) 4-40 x 3/16"

 

Screws

 

NOTE: Using screws longer

 

than 3/16” will damage the

 

unit and void the warranty.

 

Use 2 mounting holes on

 

opposite corners.

Rack mounting of the amplifier

4.

Attach the false front panel (provided with rack shelf part

 

#60-190-01) to the unoccupied side of the rack (as shown

 

above), or install a second half-rack-width device in that

 

side by repeating steps 1 through 3.

5. Attach the rack shelf to the rack using four 10-32 x ¾" bolts (provided). Insert the bolts through #10 beveled washers, then through the holes in the rack, as shown above.

Rack mounting ventilation recommendations

Excessive heat can decrease the optimal lifetime of the power amplifier. An over temp indicator LED on the front panel of the amplifier lights red whenever the recommended ambient temperature has been exceeded (see "Front Panel Features and Operation" in chapter 3).

To reduce the chances for an over temp condition, the XPA(s) should be arranged in a rack environment so that adequate airflow is available both above and below the XPA whenever possible. No more than two XPAs should be arranged one- on-top-of-the-other in a rack without an open space between them, as shown in the following illustration. An XPA can also be arranged above or below another non-XPA device, but there must be an open space both above and below those devices.

2-4

XTRA Series • Installation

XTRA Series • Installation

2-5

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Half-Rack 2-Channel and Mono Channel Audio Power AmplifiersPrecautions Extron’s WarrantyEnglish Consignes de Sécurité Français Table of Contents Table of Contents, cont’d IntroductionXtra Series Introduction FeaturesAbout this Manual Terms used in this manualIntroduction, cont’d InstallationApplication Examples InstallationMounting the XPA 1002 and XPA Tabletop useInstallation, cont’d Rack mountingSide by repeating steps 1 through UL requirements Flexible conduit adapter kit installationReplace the cover of the XPA by attaching the 8 screws that NeutralOperation ThreePower indicator LED This LED lights Front Panel Features and OperationOver Temp indicator LED This LED lights red when Limiter/Protect indicator LEDs channels 1 and 2 TheseSignal indicator LEDs channels 1 and 2 These LEDs Operation, cont’d Rear Panel Features and OperationInput signal is detected on the corresponding channel Level adjustment channels 1 and 2 Use a Tweeker orSet the source devices volume to its maximum volume To adjust the XPA amplifiers input level, do the followingRemote control connector The 3.5 mm 5-pin captive screw Operation, cont’d2 for the output channels, wire the included 4-pole Stereo audio output connector channels 1 and 2 MarkedHigh pass filter toggle switch Use a Tweeker or small Remote volume controlUnplug the IEC power cord from the power amplifier Bridged mono outputWire the input as shown in the following diagram ReferenceXtra Series Specifications Specifications, Part Numbers, and AccessoriesGeneral Specifications, Part Numbers, Accessories, cont’dOptional Accessories Specifications, Part Numbers, Accessories, cont’d Specifications, Part Numbers, Accessories, cont’d
Related manuals
Manual 28 pages 30.34 Kb

XPA 1002, XPA 2001100V, XPA 200170V, XTRA SERIES specifications

The Extron XTRA Series is designed to redefine performance in the realm of AV system control and signal processing. This extensive lineup comprises high-quality products that cater to the demands of modern AV environments, ensuring seamless integration and exceptional functionality.

One of the hallmark features of the XTRA Series is its advanced signal routing capabilities. With support for a variety of audio and video formats, including HDMI, HDBaseT, and analog signals, users can easily manage and distribute content across multiple displays and zones. This versatility is crucial for settings such as educational institutions, corporate environments, and large venues where different types of media are routinely used.

A standout characteristic of the XTRA Series is its robust control capabilities. The series incorporates Extron's signature GlobalViewer Enterprise software, enabling users to monitor and manage AV devices remotely. This feature not only simplifies system administration but also enhances troubleshooting efficiency, allowing technicians to quickly identify and resolve issues without needing to be physically present.

In terms of technology, the XTRA Series is built on Extron's advanced DSP (Digital Signal Processing) platform. This ensures superior audio quality, with features like automatic gain control, equalization, and feedback suppression, which are essential for delivering clear and articulate sound in any environment. Additionally, the series includes built-in video scaling and switching technologies, allowing for high-resolution output that maintains the integrity of the original media.

Another important aspect of the XTRA Series is its user-friendly interface. Many products in this lineup are designed with customizable touch panels and intuitive control systems that can be tailored to meet the specific needs of various users. This adaptability makes it easy for anyone, regardless of technical expertise, to operate and manage AV systems effectively.

The XTRA Series is also designed with reliability in mind. With durable construction and rigorous testing processes, these products are built to perform consistently in high-demand environments. This reliability is further complemented by Extron's dedicated customer support, providing users with the assistance and resources needed to maximize their system's capabilities.

Overall, the Extron XTRA Series stands as a testament to innovation in AV technology, combining sophisticated signal processing, intuitive control, and exceptional reliability to provide comprehensive solutions for a wide array of applications. Whether for corporate environments, educational facilities, or large-scale events, the XTRA Series ensures that users enjoy a seamless and enriched audio-visual experience.
Top Page Image Contents