English
Installing Your Wine Cellar
Unpacking Your Wine Cellar
1.Remove all packaging material. This includes the foam base and all adhesive tape holding the wine cellar accessories inside and outside.
2.Inspect and remove any remains of packing, tape or printed materials before powering on the wine cellar.
Leveling Your Wine Cellar
•Your wine cellar has four leveling legs which are located in the
front and rear corners of your wine cellar. After properly placing your wine cellar in its final position, you can level your wine cellar.
•Leveling legs can be adjusted by turning them clockwise to raise your wine cellar or by turning them counterclockwise to lower your wine cellar. The wine cellar door will close easier when the leveling legs are extended.
Proper Air Circulation
•To assure your wine cellar works at the maximum efficiency it was designed for, you should install it in a location where there is proper air circulation, plumbing and electrical connections.
•The following are recommended clearances around the wine cellar: Sides……………2" (50mm)
Top....................2" (50mm) Back..................2" (50mm)
•Do not over fill your wine cellar for proper wine cooling.
Note: If your wine cellar has been tilted for any reason, wait 24 hours before plugging it in.
4