Haier HDE-2580EGB Servicing, Door, Control panel, Interior walls, Caution MICROWAVE RADIATION

Page 15

Suggest you perform below steps after every time use.

Never use hard detergent, gasoline, abrasive powder or metal brush to clean any part of the appliance. Clean the oven at regular intervals

Disconnect the power supply cord before cleaning. And if possible leave the door open to inactive the oven during cleaning.

Exterior:

The outside may be cleaned wipe with a soft and damp cloth. Avoid the use of harsh abrasive cleaners.

Door:

Wipe the door and window on both sides, the door seals and adjacent parts frequently with a damp cloth to remove any spills or spatters. Do not use abrasive cleaners.

Control panel:

Care should be taken in cleaning the control panel. Wipe the panel with a cloth dampened slightly. Do not scrub or use any sort of chemical cleaners.

Interior walls:

To clean the interior surfaces, wipe with a soft and damp cloth for hygienic reasons. After use wipe the waveguide cover in the oven with a soft damp cloth to remove any food splashed. Buildup splashes may overheat and begin to smoke or catch fire. Do not remove the waveguide cover.Do not use a commercial oven cleaner, abrasive or harsh cleaners and scouring pads on any part of your microwave oven. Never spray oven cleaners directly onto any part of your oven.

Turntable /Rotaing ring/Roating axis:

After cooling down, Wash with mild soapy water and dry thoroughly.

Tip:

When the microwave oven has been used for a long time, there may be some strange odors exist in oven, following 3 methods can get rid of them .1. Place several lemon slices in a cup, the heat with high power for 2-3 minutes . 2. Place a cup of red tea in oven, then heat with high power. 3. Put some orange peel into oven, then heat them with high power for 1 minute.

SERVICING

Warning: it is hazardous for anyone, other than a qualified service technician, to carry out any service for repairing operation which involves removal of any cover which gives protection against exposure to microwave energy.

Caution: MICROWAVE RADIATION

Warning:The temperature of accessible surface may be high when the appliance is operating.

Do not become exposed to radiation from the microwave generator or other parts conducting microwave energy.

During servicing below listed parts are liable to be removed and give access to potentials above250V to earth.

1.Magnetron

2.High voltage transformer

3.High voltage capacitor

4.High voltage diode

5.High voltage fuse

14

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Please read this booklet carefully before fixing and using and HDE-2580EGBsave it for future reference OPERATION THEORY OF MICROWAVE OVEN INSTALLATION OF MICROWAVE OVEN2 The appliance must be positioned so that the plug is accessible c Reference plate thickness between 18 and 20mm ② INSTALLATIONExhaust Port L≥272mm*W≥72mm Cavity L560mm*H360mm*D550mm Intake L≥272mm*W≥72mmThe side with gap should be installed at the bottom of MWO Fig.4 eFinal assembly as shown in Fig.5 Fig.5fCabinet airflow chart as shown in Fig.6 dSecure ornamental frame to holders,as shown in Fig.4FOR THE FIRST USE UTENSILS GUIDELINEIMPORTANT SAFEGUARDS Household use only PRODUCT INTRODUCTION 1. Before cooking 2. Time.Weight/Auto Cooking knob3. Pause/Cancel OPERATION OF CONTROL PANEL7. Microwave cooking 4. Clock setting24 hours5. Auto reminder 6. Child lock function8. Express 9.Grill10. Grill Combi Minced Beef 11. Auto DefrostDefrost guide Steaks chopAuto cook table Weight.Time/Auto Cooking knob4. Turn Weight.Time/Auto Cooking knob 12. Auto Cooking5. You may check the preset starting time 2.2 Turn Time.Weight/Auto Cooking knob to set cooking time13. Automatic starting delay function 14. Multi-sequence cookingCLEANING AND MAINTENANCE The oven should be cleaned regularly and any food deposits removedMICROWAVE COOKING TIP Interior walls SERVICINGDoor Control panel1. Unproper fitting of magnetron
Top Page Image Contents