Haier DW15-PFE1 Cancelling or modifying a cycle, Load Button for DW15-PFE2, To select 1/2 load

Page 23

Cancelling or modifying a cycle

A cycle that is underway can be modified if it has only been running for a short time. Otherwise, the detergent may have already been used, and the appliance may have already drained the wash water. If this is the case, the detergent dispenser must be refilled ( see the paragraph entitled, “ Loading the detergent ”).

To modify a cycle that is already underway, press the button“A ” , all of the settings will be cancelled. To set a new cycle, follow the instructions contained in the paragraph entitled “Switching the dish- washer ON”.

A

1/2 Load Button (for DW15-PFE2**)

This button E (see" Close-up View (Control Panel), letter " B ") makes it possible to wash dishes using only the upper rack if there are not enough dishes for a full load. This will allow you to save on water and energy consumption.

To select 1/2 load:

Select the programme ( see the paragraph entitled“ Switching the dishwaher ON”)

Press the 1/2 load button “B ” , 1/2 load indicator “C ” blinks.

If the door is closed, after 5 seconds, the programme starts automatically.

-Please keep in mind that the amount of detergent should also be adapted to the 1/2 load.

-To cancel the 1/2 load, you can press the 1/2 load button “B ” again ,until the 1/2 load indicators

“C” goes out.

C

B

21

Image 23

Contents Dishwasher DW15-PFE1**/PFE2 Instructions for Use Page Index During normal use Safety informationDuring installation At time of deliveryIf your family includes children If a fault occursWhen disposing of old appliances Cold water connection InstallationPositioning the appliance Levelling the applianceElectrical Connection Drain hose connectionPlease follow below pictures step by step How to remove the top of your dishwasherDW15-PFE1 DW15-PFE2 Getting to know your dishwasherClose-up view control panel Models explanationDishwasher interior For DW15-PFE1 How to fill the saltSalt Loading the salt into the containerWater Hardness Adjusting salt consumptionLoading the rinse aid How to fill rinse aidRinse aid Damage to glassware and other dishes Not suitable for the dishwasherWhat you should not put into the dishwasher Our recommendationPull out the rack to load the dishwasher How to use the lower rackHow to use the upper rack Knife rack ShelfLoading the detergent How to fill the detergent dispenserDetergent Soak Programme overviewEN50242 test with rinse aid setting Programme data Washing dishesProgramme selection Earn savingsTurn on the tap Switching the dishwasher onSwitching the dishwasher OFF End of programmeInterrupping the programme Delayed start programming for DW15-PFE2Goes out Cancelling or modifying a cycleLoad Button for DW15-PFE2 To select 1/2 loadHow to keep your dishwasher in shape Rinse-aid for DW15-PFE2 Care and maintenanceOverall condition of appliance Dishwasher salt for DW15-PFE2Spray arms Clean both spray arms under running waterWith the appliance itself Fault findingResolving minor problems yourself Problems When the appliance is switched onRemnants of detergent stuck inside dispenser Lower spray arm rotates with difficultyLid in detergent compartment cannot be closed With the dishes,cutlery, etc During washingTraces of rust on cutlery Plastic items are discolouredDishes,cultlery,etc.have not been dried Glasses have a dull appearanceWidth 60 cm Depth Height 85 cm Capacity Technical dataFor Switzerland only Important informationGeneral information Page Overflow switch Heater Flowmeter Water level switch Overflow switch HeaterWiring box Way valve Door switch Softener valve