Installation and Rear Panel, cont’d
1U Universal Rack Shelf
1/2 Rack Width Front False
Faceplate
To mount the DA AV EQ under a desk, podium, or table top,
1. | If rubber feet were previously attached to the bottom of |
| the unit, remove them. |
2. | Remove the two screws from one side of the unit. Retain |
| the screws for possible later reassembly. |
3. | Attach one bracket to the side of the unit, using the |
| provided machine screws. |
4. | Repeat steps 2 and 3 on the other side of the unit. |
Front false faceplate uses 2 screws.
Use the 2 mounting holes on opposite corners.
(2)
Using screws longer than 3/16” will damage the unit and void the warranty.
5. | Hold the DA with the attached brackets against the |
| underside of the table or other furniture. On the mounting |
| surface, mark the location of the bracket’s screw holes. |
6. | Drill pilot holes 1/4" (6.4 mm) deep and 3/32" (2 mm) in |
| diameter into the table or desk top at the marked screw |
| locations. The holes should be drilled from the underside |
| or inside (concealed side) of the furniture where the |
| amplifier will be located. |
7. | Insert #8 wood screws into the four pilot holes. Tighten |
| each screw into the mounting surface until slightly less |
| than 1/4" of the screw head protrudes. |
Mounting a DA AV EQ on a 9.5" deep rack shelf
Furniture mounting
Under-desk mounting the DA AV EQ
8. | Align the mounting screws with the slots in the brackets |
| and place the unit against the surface, with the screws |
| through the bracket slots. |
9. | Slide the unit slightly forward or back, then tighten all |
| four screws to secure it in place. |
DA AV EQ Series • Installation and Rear Panel | DA AV EQ Series • Installation and Rear Panel |