Extron electronic DA 6V EQ, DA 6SVA EQ Rear Panel Features and Cabling, Through-desk mounting

Installation and Rear Panel, cont’d

Through-desk mounting

Mount the DA AV EQ through a desk or table, using the optional through-desk mounting kit (part #70-077-02).

Through-desk mounting the DA AV EQ

1.	Mark the opening through which the unit will be
	mounted — approximately 1.8" by 8.9" (4.6 cm by 22.6 cm).
2.	Cut out the material from the installation area with a
	jigsaw.
3.	Drill pilot holes 1/4" (6.4 mm) deep and 3/32" (2 mm) in
	diameter in the desk or table at the locations of the
	mounting bracket screws. The holes should be drilled
	from the underside or inside (concealed side) of the
	furniture where the amplifier will be located.
4.	Using the four provided wood screws, attach the brackets
	to the mounting surface.
5.	Slide the unit up and down or back and forth in the
	mounting brackets until the face of the DA is at the desired
	height. Tighten the screws that secure the bracket in place.
	If the screws are inaccessible to a screwdriver,
	a.	Mark the location of the brackets relative to the
		screws.
	b.	Remove the DA from inside the furniture.

c. Tighten the screws.

d. Replace the DA inside the surface (repeat step 4).

Rear Panel Features and Cabling

The following diagrams show the rear panel configurations of the 10 models in the DA AV EQ series.

12

100-240V 0.2A INPUT OUTPUTS

		1	3	5	EQ
					6V
	HIGH Z				DA
	75 Ohm	2	4	6
50/60 Hz	LOOP-THRU

1		2	4	6
DA 6V EQ rear panel
		12
100-240V	0.2A	INPUT		OUTPUTS	OUTPUTS
				INPUT

1

3

5

L 1

R

L 3

R

L 5

R

EQ

6AV

HIGH Z

2

4

L 6

L

R

L

R

L

R

R

DA

75 Ohm

2

4

6

50/60 Hz

LOOP-THRU

1 2 4 6 8 10

DA 6AV EQ rear panel

		12
100-240V	0.2A	INPUT		OUTPUTS		INPUT			OUTPUTS			RCA EQ
			1	3	5	L
		HIGH Z										6AV
		75 Ohm				R						DA
			2	4	6		1	2	3	4	5	6
50/60 Hz		LOOP-THRU

1 2 4 6 9 11

DA 6AV RCA EQ rear panel

2-6 DA AV EQ Series • Installation and Rear Panel DA AV EQ Series • Installation and Rear Panel 2-7