Installation and Rear Panel, cont’d
2Passive
This connector functions as an input on the DA 12V/6V and 8V/4V Dual EQ models when they are operating in Dual mode.
3Passive Loop-Thru connector (S-video) — (DA 6SV EQ,
DA 6SVA EQ, and DA 6SVA RCA EQ only) Connect a monitor to this female
4Termination toggle switch — (All models except DA 6A,
DA 12V/6V Dual EQ, and DA 8V/4V Dual EQ) Set this switch to High Z (up) if a monitor is plugged into the passive
5Dual mode toggle switch — (DA 12V/6V Dual EQ and DA 8V/4V Dual EQ only) Use this switch to toggle between operating modes.
•DA 12V/6V EQ: Switches between operating as one
•DA 8V/4V EQ: Switches between operating as one
6Video outputs
7Video outputs
8Audio input — Connect an audio input source to this female
Tip |
| Tip | L | |
Ring | L | Sleeve | ||
|
| |||
Sleeves |
| Tip |
| |
Tip | R | R | ||
Ring | Sleeve | |||
|
| |||
|
|
|
Balanced Stereo Input | Unbalanced Stereo Input |
Wiring the captive screw audio input connectors
9Audio input (RCA) — Connect an unbalanced audio input source to these female RCA connectors. (See the diagram below.)
Tip (+)
Sleeve ()
RCA plug diagram
10Audio outputs — Connect speakers to these
Tip | L | Tip | L | |
NO GROUND HERE | Ring | |||
|
| |||
Sleeves |
| Sleeves |
| |
Tip | R | Tip | R | |
NO GROUND HERE | Ring | |||
|
| |||
Unbalanced Output |
|
| Balanced Output |
CAUTION
For unbalanced audio, connect both sleeves to the center contact ground. DO NOT connect the sleeves to the negative
Do not tin the wires!
Wiring the captive screw audio output connectors
11Audio outputs (RCA) — Connect speakers to these RCA connectors. (See the plug diagram under i, above.)
12Video input (composite video) — Connect a composite video source to this female BNC connector.
13 Video input
| DA AV EQ Series • Installation and Rear Panel |