Emerson Process Management 3500 Transmitter Identify the components shown in Figure

1. Identify the components shown in Figure 5.

Figure 5.	Sensor cable to Model 3500
	9-wire cable from sensor	Model 3500
		Keyed sensor wiring connector
		(see Figure 3, page 6)
	black (drain wires		c	2	a
	from all wire sets)
		yellow	c	4	a	black (drains)
		violet	c	6	a	orange
	brown	green	c	8	a	white
		blue	c	10	a	gray
	red
		brown	c	12	a	red
	green		c	14	a
	white		c	16	a
	blue		c	18	a
	gray		c	20	a
	orange		c	22	a
	yellow		c	24	a
	violet		c	26	a
			c	28	a
			c	30	a
			c	32	a

2.Prepare the cable according to the instructions in Micro Motion’s 9-Wire Flowmeter Cable Preparation and Installation Guide.

3.Ensure that the cable has 360° shielding, continuous from the transmitter to the sensor’s junction box. Two methods can be used:

•Metallic conduit

•Shielded or armored cable

Refer to Micro Motion’s 9-Wire Flowmeter Cable Preparation and Installation Guide for specific instructions.

4.At the sensor:

a.Clip the cable drain wires.

b.Connect wiring inside the junction box housing and tighten the screws to hold the wires in place.

For information on your sensor’s junction box terminals, see the sensor installation manual or Micro Motion’s 9-Wire Flowmeter Cable Preparation and Installation Guide.

8