GENERAL INFORMATION
The Model 710 Dispense Valve is an On/Off valve designed for a continuous flow of viscous material through a dispense needle in automatic,
∙Model 710 Dispense Valve
∙Two 3 foot (.9 m) sections of pneumatic air line
∙Seal Kit
∙Operating and Maintenance Manual
SAFETY INFORMATION
This product should be used only by employees who have been given appropriate training and safety warnings as set forth in this manual. Read completely before operating.
WARNING: Do not exceed 100 psi (6.9 bar) pressure on the operating system. Do not exceed 1200 psi (82.7 bar)
material inlet pressure. Higher pressures may cause a hazard or serious injury. Note: The minimum recommended pneumatic operating system pressure is 70 psi (4.8 bar) clean/dry air.
Toxicity and flammability hazards depend upon the product being dispensed by this unit, and the user should take appropriate safety precautions as indicated on the MSDS of the product.
Always wear safety glasses.
ILLUSTRATION REFERENCES
Throughout this manual you will find references by illustration item number to the illustrations in the manual. The references are indicated by parentheses around a number such as: (7). Illustrations represent typical valve configurations. The drawings for your exact model are inserted at the back of the manual and include the part numbers for ordering replacement parts.
GENERAL ACCESSORIES
Graco Liquid Control offers a full line of standard and custom accessories for your dispensing needs including:
∙Valve Controllers
∙Syringe Feed Systems
∙Cartridge Retainers and Pressure Reservoirs
∙Titan 200 High Pressure Cartridge Feed Systems
∙Transfer Pump Feed Systems for 1, 5 and 55 gallon containers
∙Mounting Bases and Brackets
∙Custom Needles and Needle Blocks
Consult your Dispensit dealer or the factory for details.
3