Jackson JPX-300HC, JPX-300HN, JPX-300L operation manual Specification Information

(60°C) 140°F

(43.3°C) 110°F (82.2°C)180°F

1/2”

1 1/2”

20 ±5

(21.5) 5.65

(11.4) 3

SECTION 1: SPECIFICATION INFORMATION

SPECIFICATIONS of the JPX-300H/JPX-300HC/JPX-300HN

PERFORMANCE/CAPABILITIES

OPERATING CAPACITY (RACKS/HOUR)

RACKS PER HOUR

DISHES PER HOUR

GLASSES PER HOUR

OPERATING CYCLE (SECONDS)

WASH TIME

DRAIN TIME

RINSE TIME

TOTAL CYCLE TIME (MINUTES)

5 MINUTE TIMER OPERATING CYCLE (SECONDS)

WASH TIME

DRAIN TIME

RINSE TIME

TOTAL CYCLE TIME (MINUTES)

TANK CAPACITY (LITERS) (GALLONS)

WASH TANK

RINSE TANK

	ELECTRICAL REQUIREMENTS
30	WASH MOTOR HP	3/4
600

NOTE: Typical Electrical Circuit is based upon (1) 125% of the

600full amperage load of the machine and (2) typical fixed-trip cir-

cuit breaker sizes as listed in the NEC 2002 Edition. Local codes may require more stringent protection than what is dis- played here. Always verify with your electrical service con-

82	tractor that your circuit protection is adequate and meets all
28	applicable national and local codes. These numbers are pro-
	vided in this manual simply for reference and may change
10	without notice at any given time.
2
	JPX-300H/JPX-300HC:
262				RINSE		TYPICAL
	VOLTS	PH	HZ	HEATER	TOTAL	ELECTRICAL
28				RATINGS	AMPS	CIRCUIT
	208	1	50	8.2KW @ 230V	40 A	50 AMP
10	208	1	50	10KW @ 230V	47 A	60 AMP
	230	1	50	8.2KW @ 230V	47 A	60 AMP
5	230	1	50	10KW @ 230V	51 A	70 AMP
	208	1	60	8.2KW @ 230V	39 A	50 AMP
	208	1	60	10KW @ 230V	42 A	60 AMP
	230	1	60	8.2KW @ 230V	46 A	60 AMP
	230	1	60	10KW @ 230V	50 A	70 AMP
	460	3	60	8.2KW@480V	11 A	15 AMP
	460	3	60	10KW @480V	14 A	20 AMP

JPX-300HN:

TEMPERATURES					RINSE		TYPICAL
WASH--- (MINIMUM)	(65.6°C) 150°F	VOLTS	PH	HZ	HEATER	TOTAL	ELECTRICAL
					RATINGS	AMPS	CIRCUIT
RINSE---(MINIMUM)	(82.2°C) 180°F	208	1	50	N/A	12 A	15 AMP
		230	1	50	N/A	12 A	15 AMP
		115	1	60	N/A	24 A	30 AMP
WATER REQUIREMENTS		208	1	60	N/A	11 A	15 AMP
		230	1	60	N/A	12 A	15 AMP

INLET TEMPERATURE

(40°F Rise Booster Heater)

INLET TEMPERATURE

(70°F Rise Booster Heater)

INLET TEMPERATURE (JPX-300HN)

WATER LINE SIZE I.P.S. (MINIMUM) DRAIN LINE SIZE I.P.S. (MINIMUM) FLOW PRESSURE P.S.I.

NOTE: Always refer to the machine data plate for specific electrical and water requirements. The material provided on this page is for reference only and may be subject to change without notice.

JPX-300 Installation/Operation Manual 7610-002-71-26 Rev. J

Issued: 03-09-2006 Revised: N/A

2