Jackson JPX-300HC, JPX-300HN, JPX-300L Cuit breaker sizes as listed in the NEC 2002 Edition. Local

SECTION 1: SPECIFICATION INFORMATION

SPECIFICATIONS of the JPX-300L

PERFORMANCE/CAPABILITIES			ELECTRICAL REQUIREMENTS
OPERATING CAPACITY (RACKS/HOUR)			WASH MOTOR HP					3/4
	RACKS PER HOUR	24	NOTE: Typical Electrical Circuit is based upon (1) 125% of the
	DISHES PER HOUR	600
			full amperage load of the machine and (2) typical fixed-trip cir-
	GLASSES PER HOUR	600	cuit breaker sizes as listed in the NEC 2002 Edition. Local
			codes may require more stringent protection than what is dis-
			played here. Always verify with your electrical service con-
OPERATING CYCLE (SECONDS)			tractor that your circuit protection is adequate and meets all
			applicable national and local codes. These numbers are pro-
	WASH TIME	56
			vided in this manual simply for reference and may change
	DRAIN TIME	26	without notice at any given time.
	RINSE TIME	35	JPX-300L:
	TOTAL CYCLE TIME	120
						RINSE		TYPICAL
TEMPERATURES			VOLTS	PH	HZ	HEATER	TOTAL	ELECTRICAL
						RATINGS	AMPS	CIRCUIT
	WASH --- (MINIMUM)	(48.9°C) 120°F	115	1	60	N/A	14 A	20 AMP
	WASH --- (RECOMMENDED)	(60°C) 140°F	208	1	60	N/A	7 A	15 AMP
			230	1	60	N/A	7 A	15 AMP
	RINSE --- (MINIMUM)	(48.9°C) 120°F
	RINSE --- (RECOMMENDED)	(60°C) 140°F	NOTE: Always refer to the machine data plate for specific
			electrical and water requirements. The material provided on
WATER REQUIREMENTS			this page is for reference only and may be subject to change
INLET TEMPERATURE (RECOMMENDED)		(60°C) 140°F	without notice.
INLET TEMPERATURE (MINIMUM)		(48.9°C) 120°F
WATER LINE SIZE I.P.S. (MINIMUM)		1/2”
DRAIN LINE SIZE I.P.S. (MINIMUM)		1 3/8”
FLOW PRESSURE P.S.I.		20 ±5
MINIMUM CHLORINE REQUIRED (PPM)		50

JPX-300 Installation/Operation Manual 7610-002-71-26 Rev. J

Issued: 03-09-2006 Revised: N/A

3