Jackson DELTA 5 D, Delta 5 INSTALLATION/OPERATION Instructions, Installation Instructions

Page 11

SECTION 2: INSTALLATION/OPERATION INSTRUCTIONS

INSTALLATION INSTRUCTIONS

VISUAL INSPECTION: Before installing the unit, check the container and the machine for any damage. A damaged container could be an indication of damage to the unit. If there is damage to both the container and the unit, DO NOT throw away the container. The dishmachine has been inspected and packed at the factory with the expectation that it will arrive to you in new, undamaged condition. However, rough handling by carriers or others may damage the unit while in transit. If this situation does occur, do not return the unit to Ecolab; instead contact the carrier and ask them to inspect the damage to the unit and to com- plete an inspection report. You must contact the carrier within 48 hours of receiving the machine. Also, contact your Ecolab rep- resentative.

UNPACKING THE DISHMACHINE: Remove the machine from the container and inspect for any missing parts. If an item appears to be missing, contact your Ecolab representative immediately to report it.

LEVEL THE DISHMACHINE: The dishmachine(s) covered in this manual are designed to operate on

 

 

a level surface. Ensure that the machine is level from side to side and from front to back; adjust the

Raise

Lower

unit’s bullet feet as required. Failure to level the dishmachine may cause decreased washing perfor-

mance.

Frame with Adjustable Foot

 

PLUMBING THE DISHMACHINE: All plumbing connections must comply with all applicable local, state and national plumbing codes. The plumber is responsible for flushing the incoming water line prior to connecting it to remove all foreign debris that may get trapped in the valves or cause an obstruction. Any valves that are fouled by matter left in the water line and the expens- es resulting are not the responsibility of the manufacturer.

CONNECTING THE DRAIN LINE: The Omega 5 drain requires a minimum 2” NPT piping that is pitched at least 1/4” per foot. There must also be an air gap between the machine drain line and the floor sink or drain. If a grease trap is required by code, it should have a flow capacity of 5 gallons per minute.

WATER SUPPLY CONNECTION: Install the water supply line (1/2” NPT minimum) to the dishmachine line y-strainer using copper pipe. It is recommended that a water shut-off valve be installed between the main supply and the machine to allow for service. The water supply line must be capable of 20 ±5 PSI “flow” pressure at the recommended temperature as indicated on the data plate.

In areas where the water pressure fluctuates or is greater than the recommended pressure, it is sug- gested that a water pressure regulator be installed. The Omega 5 does not come with a water pressure regulator as standard equipment.

It is also recommended that a shock absorber (not supplied with the Omega 5) be installed in the incom- ing water line. This prevents line hammer (hydraulic shock), induced by the solenoid valve, which can cause damage to the equipment.

Drain Connection

Y-Strainer

PLUMBING CHECK: Slowly turn on the water supply to the machine after connecting the incoming fill line and drain line. Check for leaks and repair as required. Leaks must be repaired prior to placing the machine in operation.

Delta 5 Installation & Operation Manual 7610-003-37-08

Issued: 05-25-2007 Revised: N/A

5

Image 11
Contents For Jackson Models INSTALLATION/OPERATION & Technical ManualONE Year Limited Parts & Labor Warranty Manufacturers WarrantyStop Pare Arret MAW Nomenclature for the Models Covered in this Manual DeltaTable of Contents Section Specification Information Specification Information Dimensions INSTALLATION/OPERATION Instructions Installation Instructions INSTALLATION/OPERATION InstructionsElectrical Installation Instructions Operation Instructions INSTALLATION/INITIAL START-UP ProcedureWashing a Rack of Ware Priming Chemical Feeder Pumps Chemical Dispensing EquipmentTo Prepare Chemical Feeder Pumps for Operation INSTALLATION/OPERATION Instructions Detergent Control Section Preventative Maintenance Preventative Maintenance Section Troubleshooting Common Problems Troubleshooting SectionProblem Rinse water not at required temperature range Secton 4 Troubleshooting SectionSection Parts Section Parts Section Chemical Feeder Pump AssemblySolenoid Valve Repair Parts Kits Control BOX Assembly 2120 25, 26 QTY Description PERI-PUMP BOX Assembly Ecolab No Mfg. No Electrical Connection BOX AssemblyFrame Assembly Hood Assembly Switch Panel Assembly TUB Assembly Tub Weldment Frame and Motor Assembly Discharge Tube Connector Other parts not shown Motor & Pump AssemblyBooster Tank Assembly Incoming Plumbing Assembly Door Assembly Front Panel Assembly Section Electrical Schematics Delta 5 115V, 50/60 HERTZ, Single Phase Electrical SchematicsSection Jackson Maintenance Repair Centers Alabama to Florida Jackson Maintenance & Repair CentersFlorida to Maryland Service COMaryland to NEW York Jackson Service CompanyNEW York to Pennsylvania Jackson Maintenance & Repair CenterRhode Island to Wisconsin Wisconsin to WYOMING/INTERNATIONAL
Related manuals
Manual 2 pages 56.91 Kb

DELTA 5 D, Delta 5 specifications

The Jackson Delta 5 is a remarkable kayak that combines advanced design with cutting-edge technology, making it a top choice for both recreational users and seasoned paddlers. Designed for versatility and performance, the Delta 5 is an ideal vessel for navigating calm lakes, flowing rivers, and coastal waters.

One of the standout features of the Delta 5 is its lightweight construction. Crafted using a high-quality polyethylene material, the kayak is durable yet easy to transport. This lightweight nature does not compromise on sturdiness; the Delta 5 can withstand varying water conditions and endure the rigors of outdoor adventures.

The kayak’s design includes a pronounced hull shape that enhances stability. This allows paddlers to feel secure and confident while maneuvering through different water environments. The Delta 5 also features a shallow V-hull profile, which not only provides excellent initial stability but also allows for efficient tracking and minimized drag. As a result, paddlers can enjoy smooth gliding across the water while saving energy during long excursions.

Comfort is another hallmark of the Jackson Delta 5. The cockpit is spacious and designed for easy entry and exit, accommodating a range of body types. The adjustable seat offers ample lumbar support and is constructed with breathable materials, ensuring comfort during extended paddling sessions. Additionally, the kayak has multiple footrest positions, allowing for a customized seating arrangement that caters to individual preferences.

The Delta 5 comes equipped with innovative technologies such as the ‘Delta Seat System,’ which provides added flexibility and comfort. This system can be adjusted in various ways to suit the paddler’s needs. Furthermore, the kayak features built-in storage compartments and bungee cord rigging on the deck that allow for safe storage of gear and personal belongings, providing ample space for day trips or longer excursions.

Safety is also a primary consideration in the design of the Delta 5. The kayak includes scupper holes that facilitate drainage and reduce the risk of water accumulation within the cockpit. Bright colors and reflective materials are used in its construction to enhance visibility in the water, contributing to the safety of the paddler.

Overall, the Jackson Delta 5 is a well-rounded kayak that meets the demands of diverse paddling experiences. Its combination of lightweight construction, advanced stability features, customizable comfort options, and thoughtful safety elements makes it an excellent choice for those looking to explore the water with confidence and ease. Whether embarking on a serene paddle or tackling new challenges, the Delta 5 stands out as a reliable companion for any paddler.