Jackson AJ-44CE, AJ-80CEL, AJ-66CSL AJ-80CE/CEL Models, AJ-80CS/CSL Models, D226 Steam Booster

SECTION 1: SPECIFICATION INFORMATION

ELECTRICAL REQUIREMENTS (CONTINUED)/D226 STEAM BOOSTER PARAMETERS

AJ-80CE/CEL MODELS

				TYPICAL
VOLTS			TOTAL	ELECTRICAL
	PH	HZ	AMPS	CIRCUIT
208	3	50	68 A	90 AMP
220	3	50	62 A	80 AMP
230	3	50	63 A	80 AMP
380	3	50	34 A	45 AMP
415	3	50	25 A	35 AMP
440	3	50	22 A	30 AMP
208	1	60	91 A	125 AMP
230	1	60	84 A	110 AMP
200	3	60	53 A	70 AMP
208	3	60	54 A	70 AMP
230	3	60	50 A	70 AMP
380	3	60	34 A	45 AMP
460	3	60	25 A	35 AMP
600	3	60	22 A	30 AMP

AJ-80CS/CSL MODELS

				TYPICAL
			TOTAL	ELECTRICAL
VOLTS	PH	HZ	AMPS	CIRCUIT
208	3	50	19 A	25 AMP
220	3	50	19 A	25 AMP
230	3	50	19 A	25 AMP
380	3	50	7 A	15 AMP
415	3	50	8 A	15 AMP
440	3	50	8 A	15 AMP
208	1	60	19 A	25 AMP
230	1	60	19 A	25 AMP
200	3	60	13 A	20 AMP
208	3	60	13 A	20 AMP
230	3	60	13 A	20 AMP
380	3	60	13 A	20 AMP
460	3	60	7 A	15 AMP
600	3	60	8 A	15 AMP

NOTE: Always refer to the machine data plate for specific electrical and water requirements. The material provided on this page is for reference only and may be subject to change without notice.

D226 STEAM BOOSTER

ELECTRICAL REQUIREMENTS:
VOLTAGE (V)	200-230
FREQUENCY (HZ)	50/60
PHASE	SINGLE
WATER REQUIREMENTS:
INCOMING WATER TEMPERATURE (MINIMUM)	110°F
FLOW PRESSURE (PSI)	20±5
STEAM REQUIREMENTS:
INCOMING STEAM PRESSURE (PSIG)	15-25
HEAT EXCHANGER SPECIFICATIONS:*
TUBESIDE WORKING PRESSURE (PSI)	125
SHELLSIDE WORKING PRESSURE (PSI)	125

TUBESIDE HYDROSTATIC TEST PRESSURE (PSI) 250 SHELLSIDE HYDROSTATIC TEST PRESSURE (PSI)

	188
MAXIMUM OPERATING TEMPERATURE	295°F
MAXIMUM SHELLSIDE STEAM PRESSURE (PSI)	125

*- Indicates typical design criteria but is subject to change without notice. For more information, contact you authorized Jackson service representative.

STEAM RELIEF VALVE SET PRESSURE (PSI): 50

WATER OUTLET SAFETY VALVE SET PRESSURE (PSI): 125

AJ-44C Series Technical Manual 7610-001-76-22

Issued: 03-21-2006 Revised: N/A

4