Scan sensitivity setting - FM
Your radio will normally scan for FM broadcasts which are strong enough to give good reception. However, you may wish the
1.Press the On/Off button to switch on your radio.
2.If needed, press the DAB/FM button to select the FM band.
3.Press and hold the Info button until the display shows 'FM Scan Zone' then press the Tuning control to enter the scan zone selection menu.
4.Rotate the Tuning control to switch between Local and Distant options on the lower line of the display. The Distant option will allow the radio to find weaker signals when scanning.
The currently stored setting will be shown with an asterisk on the display.
5.Press and release the Tuning control to confirm your selection. The radio will then revert to the normal information display. The Local or Distant setting is stored in the radio and remains in force until changed or until a System Reset.
Note: The initial setting (out of the box, or after a System Reset) causes the radio to ignore weaker (or more distant) signals.
1
2
3
19