Operating your radio - Search tuning - FM
1.Carefully extend the telescopic aerial fully.
2.Press the On/Off button to switch on your radio.
3.Press the DAB/FM button to select the FM band.
4.Press and immediately release the Auto Tune button, your radio will scan in an upwards direction (low frequency to high frequency) and stop automatically when it finds a station of sufficient strength.
5.After a few seconds the display will update. The display will show the frequency of the signal found. If the signal is strong enough and there is RDS data present then the radio will display the station name.
6.To find other stations, press and release the Auto Tune button as before.
7.To scan the FM band in a downwards direction (high frequency to low frequency) press and hold down the Auto Tune button for 2 seconds and then release.
8.When the waveband end is reached your radio will recommence tuning from the opposite waveband end.
9.Adjust the Volume control to the required setting.
The use of radio station presets for selecting your preferred radio stations is described on page 17.
2
3
9
If you find that an FM broadcast has a lot of background hiss, this may often be reduced by setting the radio into Mono reception mode for the current FM station. Please refer to the section 'Stereo / Mono setting - FM' on page 18 for further details.
13