Solving problems
Cleaning the water intake filter
A filter is incorporated in the intake hose attached to the dishwasher’s shut- off valve. If your water is hard, or the pipes contain sediment; this filter may clog and prevent enough water from entering the wash cabinet. It can be cleaned as follows:
The plastic valve housing on the in- take hose contains electrical com- ponents and should not be im- mersed, or run through water.
Cleaning the filter:
Disconnect the dishwasher from electricity (unplug it or “trip” the circuit breaker).
^Turn off the main shutoff valve and unscrew the intake hose.
^Carefully remove the rubber seal.
^Remove the filter using needle nose pliers and rinse under running water.
^Return the filter and seal. Make sure they are seated correctly.
^Screw the intake hose back on the water valve, checking that it is not
^Slowly turn on the valve and test for leaks.
Installing an in-line water filter.
^If your water contains a large number of insoluble substances, a filter be- tween the valve and the intake hose connection is recommended. These filters can be purchased from the Miele Technical Service Department.
47