Safety instructions for installation

~Before connecting the appliance to the mains supply make sure that the connection data on the data plate (voltage and connected load) correspond with the mains electricity supply, otherwise the appliance could be damaged. Consult a qualified electrician if in any doubt.

~The socket and on-off switch should be easily accessible after the appliance has been built in.

~The food warming drawer may only be built in in combination with those appliances quoted by the manufacturer as being suitable. The manufacturer cannot guarantee trouble-free operation if the appliance is operated in combination with appliances other than those quoted by the manufacturer as being suitable.

~When building in the food warming drawer in combination with another suitable appliance, the food warming drawer must be fitted above a fixed interim shelf in the housing unit to ensure that the housing unit can suport both its weight and that of the other appliance.

~As the combination appliance is placed directly on top of the food warming drawer once it is built in, an interim shelf is not necessary between the two appliances.

~The appliance must be built in so that the contents of the drawer can be seen. This is to avoid scalding from hot food spilling over. There must be enough space for the drawer to be pulled out fully.

~This appliance may only be installed in mobile installations such as ships, caravans, aircraft etc. if a risk assessment of the installation has been carried out by a suitably qualified engineer.

~The food warming drawer is available in two models, which differ in height. The building-in dimensions for the food warming drawer must be added to the building-in dimensions for the combination appliance to establish the niche size required.

All dimensions in this instruction booklet are given in mm.