Changing the door hinging
^Unscrew upper hinge pin a using the spanner supplied and refit on the opposite side.
^Using a screwdriver remove covers b.
^Refit covers b from the back on the opposite side, and then click them into place at the front
^Remove cap c from door bearing bush in the door and refit on the opposite side.
^Hang the door on hinge pin a and then close the appliance door.
In the following illustration the door is not shown in the closed position to make it easier to see what happens next.
^Using a second person carefully tip the appliance back and then fit hinge pin b together with hinge bush c from below into hinge plate e on the left hand side.
^Align the door with the appliance housing using the long slot in hinge plate e. Then tighten the screws.
^Refit cover a on the
36