Building in the appliance
Building in the appliance
^Push the appliance into its housing unit.
When doing this, make sure that the mains cable does not get trapped.
^Depending on the thickness of the appliance housing unit walls, push the appliance into the niche until
– the spacer piece touches the housing unit wall a (16 mm thick walls), – or the front edges of the hinges are flush with the side walls of the housing unit b (19 mm thick walls).
The cover strip must not protrude in front of the edge of the housing unit. It must disappear completely into the niche.
^Push the hinged side of the appliance to the furniture wall.
^Align the appliance by altering the height of the adjustable feet using the spanner supplied f.
^Secure plastic bracket c to the side opposite the hinges using the M5 x 22 screws d.
^Push the appliance in until the plastic bracket is flush with the front edge of the housing unit floor e.
^To fix the appliance to the housing unit at the top and bottom
–screw the 4 x 19 mm long chip board screws a loosely into the hinge plate,
40