Building in the appliance
–screw two 4 x 19 mm long chip board screws b loosely into the middle of the long slot on the plastic bracket and then turn the plastic bracket downwards,
–Align cover strip d so that it is parallel to the housing unit ceiling. It must not protude.
–Fit screws c into cover strip d.
^Close the appliance door.
Fitting a furniture door
^A gap of 8 mm a must be set between the appliance door and the fixing bracket.
^Push fitting aids d up to the height of the furniture door: the lower edge "X" of the fitting aids must be at the same
height as the upper edge of the furniture door being fitted - see - on the diagram.
^Undo nuts b, and remove fixing bracket c, together with the fitting aids.
^Using a pencil, mark a line down the centre of the wrong side of the furniture door.
^Hang the fixing bracket with the fitting aids a onto the wrong side of the furniture door. Align the fixing bracket centrally.
^Attach the fixing bracket securely using at least 6 short 4 x 14 mm chip board screws b. (On cassette doors only use 4 screws on the edges).
^Pull the fitting aids upwards to remove them c.
^Turn them round and fit them back into the middle slots on fixing bracket d.
41