
FLAME SWITCH
WARNING: DISCONNECT THE ELECTRICAL POWER TO THE MACHINE AND FOLLOW LOCKOUT / TAGOUT PROCEDURES.
1.Remove the control panel.
2.Label and disconnect the wires to the flame switch.
3.Remove the two screws securing flame switch to control plate.
4.Remove sensor from the pilot assembly. Sensor can be accessed from the front of unit or from underneath the unit via the pilot assembly access cut out opening. The sensor is a snap in fit device.
5.When installing a new flame switch, reverse the procedure. Be sure to carefully route and attach the sensor to the pilot assembly and check for proper operation.
Remove
Probe
From Pilot
Assembly
Flame
Switch
Sensor
Ignitor
Electrode
Remove | Flame | |
Switch | ||
Screws | ||
|
IGNITOR MODULE
WARNING: DISCONNECT THE ELECTRICAL POWER TO THE MACHINE AND FOLLOW LOCKOUT / TAGOUT PROCEDURES.
1.Remove the control panel.
2.Label and disconnect the black, green, and white wires from the ignitor module.
3.Disconnect the ignitor cable from the bottom of the ignitor module.
4.Remove the two screws securing ignitor module to module bracket.
5.Remove ignitor module from module bracket.
6.When installing a new ignitor module reverse the procedure and check for proper operation.
Disconnect
Wires
Ignitor
Module
Remove Disconnect
Screw Wire
Module
Bracket
Figure G
Module Bracket
Disconnect Wires
Figure F
— 7 — | F35628 |