GAS BURNER
WARNING: DISCONNECT THE ELECTRICAL POWER TO THE MACHINE AND FOLLOW LOCKOUT / TAGOUT PROCEDURES.
1.Remove the back panel.
2.Cut shipping tie from burner.
3.To remove the burner, reach through the back of the unit and lift the burner up over the guide screw then pull the burner out through the back of the unit.
4.Replace the burner by inserting the burner through the rear of the unit, engaging the burner venturi onto the burner valve orifice at the front of unit. From the front of the unit, remove the control panel to check that the venturi is properly fitted over the orifice.
5.Reassemble the control and back panels then check for proper operation.
Guide
Screw
Burner | Orifice |
Figure H
PILOT SOLENOID
WARNING: DISCONNECT THE ELECTRICAL POWER TO THE MACHINE AND FOLLOW LOCKOUT / TAGOUT PROCEDURES.
WARNING: SHUT OFF THE GAS BEFORE SERVICING THE GRIDDLE.
1.Remove the control panel.
2.Label and disconnect the two wires connected to the solenoid.
3.Disconnect the input compression fitting and the two output compression fittings.
4.Remove the two screws attaching solenoid to single solenoid bracket and remove solenoid.
Input
Compression
Fitting
| Output | |
Remove | Compression | |
Fittings | ||
Screws | ||
|
Figure I
5.Reverse procedure to install the replacement gas solenoid.
WARNING: ALL GAS JOINTS DISTURBED DURING SERVICING MUST BE CHECKED FOR LEAKS. CHECK WITH SOAP AND WATER SOLUTION (BUBBLES).
DO NOT USE AN OPEN FLAME.
6.Verify gas pressure as outlined under the GAS PRESSURE ADJUSTMENT in Service Procedures and Adjustments. Check for proper operation.
F35628 | — 8 — |